devicetree.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Peter Geis <pgwipeout@gmail.com>
To: Jon Lin <jon.lin@rock-chips.com>
Cc: linux-spi@vger.kernel.org, Mark Brown <broonie@kernel.org>,
	Rob Herring <robh+dt@kernel.org>,
	Heiko Stuebner <heiko@sntech.de>,
	Johan Jonker <jbx6244@gmail.com>,
	Sandy Huang <hjc@rock-chips.com>,
	yifeng.zhao@rock-chips.com,
	Sugar Zhang <sugar.zhang@rock-chips.com>,
	"open list:ARM/Rockchip SoC..."
	<linux-rockchip@lists.infradead.org>,
	linux-mtd@lists.infradead.org, p.yadav@ti.com,
	Chris Morgan <macroalpha82@gmail.com>,
	devicetree <devicetree@vger.kernel.org>,
	arm-mail-list <linux-arm-kernel@lists.infradead.org>,
	Linux Kernel Mailing List <linux-kernel@vger.kernel.org>,
	Michael Turquette <mturquette@baylibre.com>,
	Stephen Boyd <sboyd@kernel.org>,
	linux-clk@vger.kernel.org
Subject: Re: [PATCH v13 0/6] Add Rockchip SFC(serial flash controller) support
Date: Mon, 16 Aug 2021 20:52:07 -0400	[thread overview]
Message-ID: <CAMdYzYobqhLAHhDU9E-iu-HMKSaGCDBMU-2OacGEZOQnF2ZyMw@mail.gmail.com> (raw)
In-Reply-To: <20210812134546.31340-1-jon.lin@rock-chips.com>

On Thu, Aug 12, 2021 at 9:49 AM Jon Lin <jon.lin@rock-chips.com> wrote:
>

Good Evening,

Tested successfully on the rk3566 based Quartz64 Model A.
Tested-by: Peter Geis <pgwipeout@gmail.com>

Very Respectfully,
Peter Geis

>
>
> Changes in v13:
> - Provide independent interfaces to obtain RX TX FIFO status respectively
> - Add more debug information
> - Depress DMA limitation
>
> Changes in v12:
> - Remove useless oneOf lable
> - Add sfc controller discription
> - Remove the limitation of SFC_MIN_SPEED_HZ
> - Add IRQ_NONE method for irq handler
> - Add SPI_MASTER_HALF_DUPLEX flags
> - Add sfc interrupt mask bits and status register initial progress
>
> Changes in v11:
> - The tx is set to 1 for Odroid Go Advance device
>
> Changes in v10:
> - Fix dma transfer logic
>
> Changes in v9:
> - Separate DMA IRQ setting and wait_completion from DMA fifo transfer
>   function to make dma_status_poll be possible(Which I will implement
>   in u-boot)
> - Add SFC Kconfig detail comment
>
> Changes in v8:
> - Fix indent 4 to 2 in yaml
>
> Changes in v7:
> - Fix up the sclk_sfc parent error in rk3036
> - Unify to "rockchip,sfc" compatible id because all the feature update
>   will have a new IP version, so the driver is used for the SFC IP in
>   all SoCs
> - Change to use node "sfc" to name the SFC pinctrl group
> - Add subnode reg property check
> - Add rockchip_sfc_adjust_op_size to workaround in CMD + DUMMY case
> - Limit max_iosize to 32KB
>
> Changes in v6:
> - Add support in device trees for rv1126(Declared in series 5 but not
>   submitted)
> - Change to use "clk_sfc" "hclk_sfc" as clock lable, since it does not
>   affect interpretation and has been widely used
> - Support sfc tx_dual, tx_quad(Declared in series 5 but not submitted)
> - Simplify the code, such as remove "rockchip_sfc_register_all"(Declared
>   in series 5 but not submitted)
> - Support SFC ver4 ver5(Declared in series 5 but not submitted)
> - Add author Chris Morgan and Jon Lin to spi-rockchip-sfc.c
> - Change to use devm_spi_alloc_master and spi_unregister_master
>
> Changes in v5:
> - Add support in device trees for rv1126
> - Support sfc tx_dual, tx_quad
> - Simplify the code, such as remove "rockchip_sfc_register_all"
> - Support SFC ver4 ver5
>
> Changes in v4:
> - Changing patch back to an "RFC". An engineer from Rockchip
>   reached out to me to let me know they are working on this patch for
>   upstream, I am submitting this v4 for the community to see however
>   I expect Jon Lin (jon.lin@rock-chips.com) will submit new patches
>   soon and these are the ones we should pursue for mainlining. Jon's
>   patch series should include support for more hardware than this
>   series.
> - Clean up documentation more and ensure it is correct per
>   make dt_binding_check.
> - Add support in device trees for rk3036, rk3308, and rv1108.
> - Add ahb clock (hclk_sfc) support for rk3036.
> - Change rockchip_sfc_wait_fifo_ready() to use a switch statement.
> - Change IRQ code to only mark IRQ as handled if it handles the
>   specific IRQ (DMA transfer finish) it is supposed to handle.
>
> Changes in v3:
> - Changed the name of the clocks to sfc/ahb (from clk-sfc/clk-hsfc).
> - Changed the compatible string from rockchip,sfc to
>   rockchip,rk3036-sfc. A quick glance at the datasheets suggests this
>   driver should work for the PX30, RK180x, RK3036, RK312x, RK3308 and
>   RV1108 SoCs, and possibly more. However, I am currently only able
>   to test this on a PX30 (an RK3326). The technical reference manuals
>   appear to list the same registers for each device.
> - Corrected devicetree documentation for formatting and to note these
>   changes.
> - Replaced the maintainer with Heiko Stuebner and myself, as we will
>   take ownership of this going forward.
> - Noted that the device (per the reference manual) supports 4 CS, but
>   I am only able to test a single CS (CS 0).
> - Reordered patches to comply with upstream rules.
>
> Changes in v2:
> - Reimplemented driver using spi-mem subsystem.
> - Removed power management code as I couldn't get it working properly.
> - Added device tree bindings for Odroid Go Advance.
>
> Changes in v1:
> hanges made in this new series versus the v8 of the old series:
> - Added function to read spi-rx-bus-width from device tree, in the
>   event that the SPI chip supports 4x mode but only has 2 pins
>   wired (such as the Odroid Go Advance).
> - Changed device tree documentation from txt to yaml format.
> - Made "reset" message a dev_dbg from a dev_info.
> - Changed read and write fifo functions to remove redundant checks.
> - Changed the write and read from relaxed to non-relaxed when
>   starting the DMA transfer or reading the DMA IRQ.
> - Changed from dma_coerce_mask_and_coherent to just
>   dma_set_mask_and_coherent.
> - Changed name of get_if_type to rockchip_sfc_get_if_type.
>
> Chris Morgan (6):
>   dt-bindings: rockchip-sfc: Bindings for Rockchip serial flash
>     controller
>   spi: rockchip-sfc: add rockchip serial flash controller
>   arm64: dts: rockchip: Add SFC to PX30
>   arm: dts: rockchip: Add SFC to RV1108
>   arm64: dts: rockchip: Add SFC to RK3308
>   arm64: dts: rockchip: Enable SFC for Odroid Go Advance
>
>  .../devicetree/bindings/spi/rockchip-sfc.yaml |  91 +++
>  arch/arm/boot/dts/rv1108.dtsi                 |  37 +
>  arch/arm64/boot/dts/rockchip/px30.dtsi        |  38 +
>  arch/arm64/boot/dts/rockchip/rk3308.dtsi      |  37 +
>  .../boot/dts/rockchip/rk3326-odroid-go2.dts   |  16 +
>  drivers/spi/Kconfig                           |  12 +
>  drivers/spi/Makefile                          |   1 +
>  drivers/spi/spi-rockchip-sfc.c                | 694 ++++++++++++++++++
>  8 files changed, 926 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
>  create mode 100644 drivers/spi/spi-rockchip-sfc.c
>
> --
> 2.17.1
>
>
>
>
> _______________________________________________
> Linux-rockchip mailing list
> Linux-rockchip@lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-rockchip

  parent reply	other threads:[~2021-08-17  0:52 UTC|newest]

Thread overview: 10+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2021-08-12 13:45 [PATCH v13 0/6] Add Rockchip SFC(serial flash controller) support Jon Lin
2021-08-12 13:45 ` [PATCH v13 1/6] dt-bindings: rockchip-sfc: Bindings for Rockchip serial flash controller Jon Lin
2021-08-12 13:45 ` [PATCH v13 2/6] spi: rockchip-sfc: add rockchip " Jon Lin
2021-08-12 13:45 ` [PATCH v13 3/6] arm64: dts: rockchip: Add SFC to PX30 Jon Lin
2021-08-12 13:45 ` [PATCH v13 4/6] arm: dts: rockchip: Add SFC to RV1108 Jon Lin
2021-08-12 13:46 ` [PATCH v13 5/6] arm64: dts: rockchip: Add SFC to RK3308 Jon Lin
2021-08-12 13:46   ` [PATCH v13 6/6] arm64: dts: rockchip: Enable SFC for Odroid Go Advance Jon Lin
2021-08-17  0:52 ` Peter Geis [this message]
2021-08-17 14:22 ` (subset) [PATCH v13 0/6] Add Rockchip SFC(serial flash controller) support Mark Brown
2021-08-18 22:14 ` Heiko Stuebner

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=CAMdYzYobqhLAHhDU9E-iu-HMKSaGCDBMU-2OacGEZOQnF2ZyMw@mail.gmail.com \
    --to=pgwipeout@gmail.com \
    --cc=broonie@kernel.org \
    --cc=devicetree@vger.kernel.org \
    --cc=heiko@sntech.de \
    --cc=hjc@rock-chips.com \
    --cc=jbx6244@gmail.com \
    --cc=jon.lin@rock-chips.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-clk@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mtd@lists.infradead.org \
    --cc=linux-rockchip@lists.infradead.org \
    --cc=linux-spi@vger.kernel.org \
    --cc=macroalpha82@gmail.com \
    --cc=mturquette@baylibre.com \
    --cc=p.yadav@ti.com \
    --cc=robh+dt@kernel.org \
    --cc=sboyd@kernel.org \
    --cc=sugar.zhang@rock-chips.com \
    --cc=yifeng.zhao@rock-chips.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).