From: Ulf Hansson <ulf.hansson@linaro.org>
To: Kishon Vijay Abraham I <kishon@ti.com>
Cc: Tony Lindgren <tony@atomide.com>,
Adrian Hunter <adrian.hunter@intel.com>,
Rob Herring <robh+dt@kernel.org>,
Mark Rutland <mark.rutland@arm.com>,
Russell King <linux@armlinux.org.uk>,
"linux-mmc@vger.kernel.org" <linux-mmc@vger.kernel.org>,
devicetree@vger.kernel.org,
Linux Kernel Mailing List <linux-kernel@vger.kernel.org>,
linux-omap <linux-omap@vger.kernel.org>,
Linux ARM <linux-arm-kernel@lists.infradead.org>
Subject: Re: [PATCH v3 00/11] mmc: sdhci-omap: Add UHS/HS200 mode support
Date: Thu, 15 Mar 2018 09:47:10 +0100 [thread overview]
Message-ID: <CAPDyKFrnPQs3B2QN7tf3UH0JYjqkpS1YDhq0s3scads3exPCCg@mail.gmail.com> (raw)
In-Reply-To: <20180307132020.30951-1-kishon@ti.com>
On 7 March 2018 at 14:20, Kishon Vijay Abraham I <kishon@ti.com> wrote:
> Add UHS/HS200 mode support in sdhci-omap. The programming sequence
> for voltage switching, tuning is followed from AM572x TRM
> http://www.ti.com/lit/ug/spruhz6i/spruhz6i.pdf
> (Similar to all AM57x/DRA7x SoCs). The patch series also implements
> workaround for errata published in
> http://www.ti.com/lit/er/sprz429k/sprz429k.pdf
>
> patches are created on top of
> git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc.git next
>
> Patches in v2 already applied to mmc -next are dropped from the
> series.
>
> Changes from v2:
> *) Changed SW timeout logic as per Adrians's suggestion
> *) Validated SDIO with the current patches (added a couple of fixes
> found while adding SDIO support).
> *) Used soc_device_match() instead of pdata-quirks as per Tony's
> suggestions.
>
> Changes from v1:
> *) Only poll on DAT0 and DATI for card_busy status
> *) Cleanup iodelay patch as suggested by Tony.
> *) Added quirk to disable HW timeout
> *) Use the existing data timer but program a relatively accurate
> SW timeout value (Impacts all platforms)
> *) Fix a bug in sdhci which was using data_timer for non data line
> commands
>
> Kishon Vijay Abraham I (11):
> mmc: sdhci-omap: Fix when capabilities are obtained from
> SDHCI_CAPABILITIES reg
> mmc: sdhci-omap: Remove setting ADMA capability in driver
> mmc: sdhci-omap: Workaround for Errata i843
> mmc: sdhci-omap: Invoke sdhci_get_of_property to read sdhci dt
> properties
> mmc: sdhci: Disable HS200 mode if controller can't support 1.8v
> mmc: sdhci: Add quirk to disable HW timeout
> mmc: sdhci: Program a relatively accurate SW timeout value
> mmc: sdhci-omap: Workaround for Errata i834
> dt-bindings: sdhci-omap: Add K2G specific binding
> mmc: sdhci-omap: Add support for MMC/SD controller in k2g SoC
> mmc: sdhci-omap: Add sdhci_omap specific ops for enable_sdio_irq
>
> .../devicetree/bindings/mmc/sdhci-omap.txt | 2 +
> drivers/mmc/host/sdhci-omap.c | 78 +++++++++++++++++++---
> drivers/mmc/host/sdhci.c | 75 +++++++++++++++++----
> drivers/mmc/host/sdhci.h | 15 +++++
> 4 files changed, 148 insertions(+), 22 deletions(-)
>
> --
> 2.11.0
>
Overall this looks good to me, however it seems like we need to give
Adrian a little more time to comment.
Kind regards
Uffe
next prev parent reply other threads:[~2018-03-15 8:47 UTC|newest]
Thread overview: 31+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-03-07 13:20 [PATCH v3 00/11] mmc: sdhci-omap: Add UHS/HS200 mode support Kishon Vijay Abraham I
2018-03-07 13:20 ` [PATCH v3 01/11] mmc: sdhci-omap: Fix when capabilities are obtained from SDHCI_CAPABILITIES reg Kishon Vijay Abraham I
2018-03-15 14:17 ` Adrian Hunter
2018-03-07 13:20 ` [PATCH v3 02/11] mmc: sdhci-omap: Remove setting ADMA capability in driver Kishon Vijay Abraham I
2018-03-15 14:18 ` Adrian Hunter
2018-03-07 13:20 ` [PATCH v3 03/11] mmc: sdhci-omap: Workaround for Errata i843 Kishon Vijay Abraham I
2018-03-15 14:24 ` Adrian Hunter
2018-03-07 13:20 ` [PATCH v3 04/11] mmc: sdhci-omap: Invoke sdhci_get_of_property to read sdhci dt properties Kishon Vijay Abraham I
2018-03-15 14:27 ` Adrian Hunter
2018-03-07 13:20 ` [PATCH v3 05/11] mmc: sdhci: Disable HS200 mode if controller can't support 1.8v Kishon Vijay Abraham I
2018-03-15 10:58 ` Adrian Hunter
2018-03-07 13:20 ` [PATCH v3 06/11] mmc: sdhci: Add quirk to disable HW timeout Kishon Vijay Abraham I
2018-03-15 11:26 ` Adrian Hunter
2018-03-07 13:20 ` [PATCH v3 07/11] mmc: sdhci: Program a relatively accurate SW timeout value Kishon Vijay Abraham I
2018-03-15 13:13 ` Adrian Hunter
2018-03-16 6:29 ` Kishon Vijay Abraham I
2018-03-16 14:21 ` Adrian Hunter
2018-03-19 9:20 ` Kishon Vijay Abraham I
2018-03-19 10:00 ` Adrian Hunter
2018-03-19 10:19 ` Kishon Vijay Abraham I
2018-03-20 9:48 ` Kishon Vijay Abraham I
2018-04-04 12:48 ` Adrian Hunter
2018-03-07 13:20 ` [PATCH v3 08/11] mmc: sdhci-omap: Workaround for Errata i834 Kishon Vijay Abraham I
2018-03-07 13:20 ` [PATCH v3 09/11] dt-bindings: sdhci-omap: Add K2G specific binding Kishon Vijay Abraham I
2018-03-07 13:20 ` [PATCH v3 10/11] mmc: sdhci-omap: Add support for MMC/SD controller in k2g SoC Kishon Vijay Abraham I
2018-03-07 13:20 ` [PATCH v3 11/11] mmc: sdhci-omap: Add sdhci_omap specific ops for enable_sdio_irq Kishon Vijay Abraham I
2018-03-15 14:34 ` Adrian Hunter
2018-03-07 15:12 ` [PATCH v3 00/11] mmc: sdhci-omap: Add UHS/HS200 mode support Tony Lindgren
2018-03-15 8:47 ` Ulf Hansson [this message]
2018-03-15 8:52 ` Adrian Hunter
2018-03-15 10:02 ` Kishon Vijay Abraham I
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=CAPDyKFrnPQs3B2QN7tf3UH0JYjqkpS1YDhq0s3scads3exPCCg@mail.gmail.com \
--to=ulf.hansson@linaro.org \
--cc=adrian.hunter@intel.com \
--cc=devicetree@vger.kernel.org \
--cc=kishon@ti.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mmc@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=linux@armlinux.org.uk \
--cc=mark.rutland@arm.com \
--cc=robh+dt@kernel.org \
--cc=tony@atomide.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).