Re: [PATCH net-next 8/8] net: phy: marvell10g: select host interface configuration

["Russell King (Oracle)" <linux@armlinux.org.uk>]

On Thu, Nov 18, 2021 at 02:46:28PM +0100, Marek Behún wrote:
> On Thu, 18 Nov 2021 09:41:27 +0000
> "Russell King (Oracle)" <linux@armlinux.org.uk> wrote:
> 
> > On Wed, Nov 17, 2021 at 11:50:50PM +0100, Marek Behún wrote:
> > > +static int mv3310_select_mactype(unsigned long *interfaces)
> > > +{
> > > +	if (test_bit(PHY_INTERFACE_MODE_USXGMII, interfaces))
> > > +		return MV_V2_33X0_PORT_CTRL_MACTYPE_USXGMII;
> > > +	else if (test_bit(PHY_INTERFACE_MODE_SGMII, interfaces) &&
> > > +		 test_bit(PHY_INTERFACE_MODE_10GBASER, interfaces))
> > > +		return MV_V2_33X0_PORT_CTRL_MACTYPE_10GBASER;
> > > +	else if (test_bit(PHY_INTERFACE_MODE_SGMII, interfaces) &&
> > > +		 test_bit(PHY_INTERFACE_MODE_RXAUI, interfaces))
> > > +		return MV_V2_33X0_PORT_CTRL_MACTYPE_RXAUI;
> > > +	else if (test_bit(PHY_INTERFACE_MODE_SGMII, interfaces) &&
> > > +		 test_bit(PHY_INTERFACE_MODE_XAUI, interfaces))
> > > +		return MV_V2_3310_PORT_CTRL_MACTYPE_XAUI;
> > > +	else if (test_bit(PHY_INTERFACE_MODE_10GBASER, interfaces))
> > > +		return MV_V2_33X0_PORT_CTRL_MACTYPE_10GBASER_RATE_MATCH;
> > > +	else if (test_bit(PHY_INTERFACE_MODE_RXAUI, interfaces))
> > > +		return MV_V2_33X0_PORT_CTRL_MACTYPE_RXAUI_RATE_MATCH;
> > > +	else if (test_bit(PHY_INTERFACE_MODE_XAUI, interfaces))
> > > +		return MV_V2_3310_PORT_CTRL_MACTYPE_XAUI_RATE_MATCH;
> > > +	else if (test_bit(PHY_INTERFACE_MODE_SGMII, interfaces))
> > > +		return MV_V2_33X0_PORT_CTRL_MACTYPE_10GBASER;  
> > 
> > Hi,
> > 
> > There are differences in the MACTYPE register between the 88X3310
> > and 88X3340. For example, the 88X3340 has no support for XAUI.
> > This is documented in the data sheet, and in the definitions of
> > these values - note that MV_V2_3310_PORT_CTRL_MACTYPE_XAUI and
> > MV_V2_3310_PORT_CTRL_MACTYPE_XAUI_RATE_MATCH are only applicable
> > to the 88X3310 (they don't use MV_V2_33X0_*).
> 
> Yes, but 88X3340 does not support XAUI, only RXAUI, it is defined in
> supported_interfaces. So PHY_INTERFACE_MODE_XAUI will never be set in
> interfaces, and thus this function can be used for both 88X3310 and
> 88X3340.

Okay, that's fine then. The only setting we will omit from this for
the 88X3340 then is MV_V2_3340_PORT_CTRL_MACTYPE_RXAUI_NO_SGMII_AN.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!