Re: [PATCH v2 16/18] ARM: dts: qcom: remove redundant binding from ipq8064 rb3011 dts

[Jonathan McDowell <noodles@earth.li>]

On Fri, Feb 18, 2022 at 02:11:59PM +0000, Jonathan McDowell wrote:
> On Fri, Feb 18, 2022 at 01:29:54AM +0100, Ansuel Smith wrote:
> > Mdio0_pins are now declared in ipq8064 dtsi. Usb phy are enabled by
> > default.
...
> > -	mdio0_pins: mdio0_pins {
> > -		mux {
> > -			pins = "gpio0", "gpio1";
> > -			function = "gpio";
> > -			drive-strength = <8>;
> > -			bias-disable;
> > -		};
> > -	};
> > -
> 
> This sets the pins to "gpio". Your earlier patch sets them to "mdio", so
> removing this will break MDIO0 on the RB3011. It's likely that your
> fixes for MDIO/QCA8K mean that the RB3011 can be switch to use the MDIO
> driver rather than mdio-gpio, but that will need tested and this change
> alone will definitely break things.

I tried the below patch to switch the RB3011 to the IPQ8064 MDIO driver
(based on qcom,ipq8064-mdio.yaml) and get:

[    1.270310] qca8k 37000000.mdio-mii:10: Switch id detected 0 but expected 13

and none of the ports on that associated switch come up. Kernel is
5.15.23 rather than latest, but there are no updates to mdio-ipq8064.c
in later kernels than I can see and none of the qca8k changes seem
relevant. Is there something else I'm missing?


diff --git a/arch/arm/boot/dts/qcom-ipq8064-rb3011.dts b/arch/arm/boot/dts/qcom-ipq8064-rb3011.dts
index c3e3070702f9..0cafee65ca22 100644
--- a/arch/arm/boot/dts/qcom-ipq8064-rb3011.dts
+++ b/arch/arm/boot/dts/qcom-ipq8064-rb3011.dts
@@ -24,13 +24,13 @@ memory@42000000 {
 		device_type = "memory";
 	};
 
-	mdio0: mdio-0 {
+	mdio0: mdio@37000000 {
 		status = "okay";
-		compatible = "virtual,mdio-gpio";
-		gpios = <&qcom_pinmux 1 GPIO_ACTIVE_HIGH>,
-			<&qcom_pinmux 0 GPIO_ACTIVE_HIGH>;
+		compatible = "qcom,ipq8064-mdio";
 		#address-cells = <1>;
 		#size-cells = <0>;
+		reg = <0x37000000 0x200000>;
+		clocks = <&gcc GMAC_CORE1_CLK>;
 
 		pinctrl-0 = <&mdio0_pins>;
 		pinctrl-names = "default";
@@ -318,7 +318,7 @@ mux {
 	mdio0_pins: mdio0_pins {
 		mux {
 			pins = "gpio0", "gpio1";
-			function = "gpio";
+			function = "mdio";
 			drive-strength = <8>;
 			bias-disable;
 		};

J.

-- 
/-\                             |  Shall I call the United Nations?
|@/  Debian GNU/Linux Developer |
\-                              |