Re: [PATCH v1 0/3] usb: dwc3: Avoid using reserved EPs

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

On Tue, Jan 21, 2025 at 11:43:21PM +0000, Thinh Nguyen wrote:
> On Mon, Jan 20, 2025, Andy Shevchenko wrote:
> > On Fri, Jan 17, 2025 at 03:38:46PM +0200, Andy Shevchenko wrote:
> > > On Thu, Jan 16, 2025 at 11:18:45PM +0000, Thinh Nguyen wrote:
> > > > On Thu, Jan 16, 2025, Andy Shevchenko wrote:

...

> > > > I'm not entirely clear on the reason for this change yet.
> > > > 
> > > > How would this even work without dwc3 managing these endpoints (all the
> > > > init/teardown/fifo allocation/start/stop flow).
> > > 
> > > You perhaps know much better how it can be done, I have access to a limited
> > > documentation and in practice if those endpoints are not skipped any gadget
> > > that allocates them simply won't work, and IIRC the entire USB transfers are
> > > stuck.
> > > 
> > > > Can you provide more info on this hardware?
> > > 
> > > I am afraid I can't provide more, sorry. I can look for some specifics,
> > > but I'm not that guy who know anything about in-SoC tracing.
> > 
> > So, here is what I found:
> > 
> > ---8<---
> > 
> > However the endpoints allocated for STM and EXI debug traffic cannot be re-allocated
> > if being used because the sideband flow control signals are hard wired to certain
> > endpoints:
> > • 1 High BW Bulk IN (IN#1) (RTIT)
> > • 1 1KB BW Bulk IN (IN#8) + 1 1KB BW Bulk OUT (Run Control) (OUT#8)
> > 
> > In device mode, since RTIT (EP#1) and EXI/RunControl (EP#8) uses External Buffer
> > Control (EBC) mode, these endpoints are to be mapped to EBC mode (to be done by
> > EXI target driver). Additionally TRB for RTIT and EXI are maintained in STM (System
> > Trace Module) unit and the EXI target driver will as well configure the TRB location for
> > EP #1 IN and EP#8 (IN and OUT). Since STM/PTI and EXI hardware blocks manage
> > these endpoints and interface to OTG3 controller through EBC interface, there is no
> > need to enable any events (such as XferComplete etc) for these end points.
> > 
> > ---8<---
> > 
> > Does it help you to understand the required quirk better?
> 
> Thanks for looking up the info. This makes more sense now. So these
> endpoints use EBC. Can you also provide this info to the commit?

Sure, since I published it already it makes no difference if it appears in the
Git log (from the publicity point of view).

-- 
With Best Regards,
Andy Shevchenko