Re: [PATCH 1/3] remoteproc: Add Arm remoteproc driver

[Sudeep Holla <sudeep.holla@arm.com>]

On Thu, Mar 14, 2024 at 08:52:59AM -0600, Mathieu Poirier wrote:
> On Wed, Mar 13, 2024 at 05:17:56PM +0000, Abdellatif El Khlifi wrote:
> > Hi Mathieu,
> >
> > On Wed, Mar 13, 2024 at 10:25:32AM -0600, Mathieu Poirier wrote:
> > > On Tue, Mar 12, 2024 at 05:32:52PM +0000, Abdellatif El Khlifi wrote:
> > > > Hi Mathieu,
> > > >
> > > > On Tue, Mar 12, 2024 at 10:29:52AM -0600, Mathieu Poirier wrote:
> > > > > > This is an initial patchset for allowing to turn on and off the remote processor.
> > > > > > The FW is already loaded before the Corstone-1000 SoC is powered on and this
> > > > > > is done through the FPGA board bootloader in case of the FPGA target. Or by the Corstone-1000 FVP model
> > > > > > (emulator).
> > > > > >
> > > > > >From the above I take it that booting with a preloaded firmware is a
> > > > > scenario that needs to be supported and not just a temporary stage.
> > > >
> > > > The current status of the Corstone-1000 SoC requires that there is
> > > > a preloaded firmware for the external core. Preloading is done externally
> > > > either through the FPGA bootloader or the emulator (FVP) before powering
> > > > on the SoC.
> > > >
> > >
> > > Ok
> > >
> > > > Corstone-1000 will be upgraded in a way that the A core running Linux is able
> > > > to share memory with the remote core and also being able to access the remote
> > > > core memory so Linux can copy the firmware to. This HW changes are still
> > > > This is why this patchset is relying on a preloaded firmware. And it's the step 1
> > > > of adding remoteproc support for Corstone.
> > > >
> > >
> > > Ok, so there is a HW problem where A core and M core can't see each other's
> > > memory, preventing the A core from copying the firmware image to the proper
> > > location.
> > >
> > > When the HW is fixed, will there be a need to support scenarios where the
> > > firmware image has been preloaded into memory?
> >
> > No, this scenario won't apply when we get the HW upgrade. No need for an
> > external entity anymore. The firmware(s) will all be files in the linux filesystem.
> >
>
> Very well.  I am willing to continue with this driver but it does so little that
> I wonder if it wouldn't simply be better to move forward with upstreaming when
> the HW is fixed.  The choice is yours.
>

I think Robin has raised few points that need clarification. I think it was
done as part of DT binding patch. I share those concerns and I wanted to
reaching to the same concerns by starting the questions I asked on corstone
device tree changes.

--
Regards,
Sudeep