Re: [PATCH v4 3/6] i2c: Introduce OF component probe function

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

On Thu, Aug 08, 2024 at 05:59:26PM +0800, Chen-Yu Tsai wrote:
> Some devices are designed and manufactured with some components having
> multiple drop-in replacement options. These components are often
> connected to the mainboard via ribbon cables, having the same signals
> and pin assignments across all options. These may include the display
> panel and touchscreen on laptops and tablets, and the trackpad on
> laptops. Sometimes which component option is used in a particular device
> can be detected by some firmware provided identifier, other times that
> information is not available, and the kernel has to try to probe each
> device.
> 
> This change attempts to make the "probe each device" case cleaner. The
> current approach is to have all options added and enabled in the device
> tree. The kernel would then bind each device and run each driver's probe
> function. This works, but has been broken before due to the introduction
> of asynchronous probing, causing multiple instances requesting "shared"
> resources, such as pinmuxes, GPIO pins, interrupt lines, at the same
> time, with only one instance succeeding. Work arounds for these include
> moving the pinmux to the parent I2C controller, using GPIO hogs or
> pinmux settings to keep the GPIO pins in some fixed configuration, and
> requesting the interrupt line very late. Such configurations can be seen
> on the MT8183 Krane Chromebook tablets, and the Qualcomm sc8280xp-based
> Lenovo Thinkpad 13S.
> 
> Instead of this delicate dance between drivers and device tree quirks,
> this change introduces a simple I2C component probe. function For a
> given class of devices on the same I2C bus, it will go through all of
> them, doing a simple I2C read transfer and see which one of them responds.
> It will then enable the device that responds.
> 
> This requires some minor modifications in the existing device tree. The
> status for all the device nodes for the component options must be set
> to "failed-needs-probe". This makes it clear that some mechanism is
> needed to enable one of them, and also prevents the prober and device
> drivers running at the same time.

...

> +int i2c_of_probe_component(struct device *dev, const char *type)

Use respective scoped variants and remove the related of_node_put() calls.

...

> +		ocs = kzalloc(sizeof(*ocs), GFP_KERNEL);

Use __free()

> +		if (!ocs) {
> +			ret = -ENOMEM;
> +			goto err_put_node;
> +		}

> +err_free_ocs:
> +	kfree(ocs);

-- 
With Best Regards,
Andy Shevchenko