Re: [PATCH v3 0/2] iio: adc: Add support for Texas Instruments ADS112C04

[Krzysztof Kozlowski <krzk@kernel.org>]

On 05/08/2026 08:43, Krzysztof Kozlowski wrote:
> On 05/08/2026 07:38, Kyle Hsieh wrote:
>> This patch series introduces support for the Texas Instruments ADS112C04
>> Analog-to-Digital Converters.
>>
>> The ADS112C04 (16-bit) is precision, low-power, delta-sigma ADCs with
>> an I2C interface. They feature a flexible input multiplexer supporting
>> single-ended and differential measurements, a programmable gain amplifier,
>> and an internal voltage reference.
>>
>> Note: While this chip shares similarities with the ADS112C14 (currently 
>> being upstreamed by David Lechner), the register maps and feature sets 
>> are sufficiently different to warrant a separate driver. However, the
>> DT bindings and channel parsing logic have been aligned with the
>> ADS112C14 conventions.
>>
>> This initial submission provides a minimal feature set (single-shot 
>> conversions and basic DRDY interrupt) covering current use cases.
>>
>> Signed-off-by: Kyle Hsieh <kylehsieh1995@gmail.com>
>> ---
>> Changes in v3:
>> - dt-bindings: iio: adc: ti,ads112c04:
>>   - Resolved dt_binding_check errors by removing redundant $ref for
>>     standard unit suffixes and fixing YAML array syntax.
> Yet you still decided NOT TO TEST it before sending.

Although after further looking this could be using properties added in
iio tree, thus bot's report about failure.

Well, if that is the case, that's unfortunate because if previous
versions were not tested by you, this one cannot be tested by the bot,
thus I look at this one as also untested.

Best regards,
Krzysztof