Re: [PATCH 1/6] dt-bindings: phy: spacemit: add SpacemiT PCIe/combo PHY

[Yao Zi <ziyao@disroot.org>]

On Wed, Aug 13, 2025 at 01:46:55PM -0500, Alex Elder wrote:
> Add the Device Tree binding for the PCIe/USB 3.0 combo PHY found in
> the SpacemiT K1 SoC.  This is one of three PCIe PHYs, and is unusual
> in that only the combo PHY can perform a calibration step needed to
> determine settings used by the other two PCIe PHYs.
> 
> Calibration must be done with the combo PHY in PCIe mode, and to allow
> this to occur independent of the eventual use for the PHY (PCIe or USB)
> some PCIe-related properties must be supplied: clocks; resets; and a
> syscon phandle.
> 
> Signed-off-by: Alex Elder <elder@riscstar.com>
> ---
>  .../bindings/phy/spacemit,k1-combo-phy.yaml   | 110 ++++++++++++++++++
>  1 file changed, 110 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/phy/spacemit,k1-combo-phy.yaml
> 
> diff --git a/Documentation/devicetree/bindings/phy/spacemit,k1-combo-phy.yaml b/Documentation/devicetree/bindings/phy/spacemit,k1-combo-phy.yaml
> new file mode 100644
> index 0000000000000..ed78083a53231
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/phy/spacemit,k1-combo-phy.yaml

...

> +  spacemit,syscon-pmu:
> +    description:
> +      PHandle that refers to the APMU system controller, whose
> +      regmap is used in setting the mode
> +    $ref: /schemas/types.yaml#/definitions/phandle

Clock controllers and ethernet controllers all use spacemit,apmu to
refer the APMU system controller. Do you think it's better to keep them
aligned?

...

> +
> +additionalProperties: false
> +
> +examples:
> +  - |
> +    #include <dt-bindings/clock/spacemit,k1-syscon.h>
> +    combo_phy: phy@c0b10000 {

This label is unnecessary.

> +        compatible = "spacemit,k1-combo-phy";
> +        reg = <0xc0b10000 0x1000>;
> +        clocks = <&syscon_apmu CLK_PCIE0_DBI>,
> +                 <&syscon_apmu CLK_PCIE0_MASTER>,
> +                 <&syscon_apmu CLK_PCIE0_SLAVE>;
> +        clock-names = "dbi",
> +                      "mstr",
> +                      "slv";
> +        resets = <&syscon_apmu RESET_PCIE0_DBI>,
> +                 <&syscon_apmu RESET_PCIE0_MASTER>,
> +                 <&syscon_apmu RESET_PCIE0_SLAVE>,
> +                 <&syscon_apmu RESET_PCIE0_GLOBAL>;
> +        reset-names = "dbi",
> +                      "mstr",
> +                      "slv",
> +                      "global";
> +        spacemit,syscon-pmu = <&syscon_apmu>;
> +        #phy-cells = <1>;
> +        status = "disabled";
> +    };

Best regards,
Yao Zi