From: Frank Li <Frank.li@nxp.com>
To: Laurentiu Mihalcea <laurentiumihalcea111@gmail.com>
Cc: Krzysztof Kozlowski <krzk+dt@kernel.org>,
Conor Dooley <conor+dt@kernel.org>,
Shawn Guo <shawnguo@kernel.org>,
Fabio Estevam <festevam@gmail.com>,
Philipp Zabel <p.zabel@pengutronix.de>,
Daniel Baluta <daniel.baluta@nxp.com>,
Shengjiu Wang <shengjiu.wang@nxp.com>,
devicetree@vger.kernel.org, imx@lists.linux.dev,
linux-arm-kernel@lists.infradead.org,
linux-kernel@vger.kernel.org,
Pengutronix Kernel Team <kernel@pengutronix.de>
Subject: Re: [PATCH v5 3/6] reset: imx8mp-audiomix: Switch to using regmap API
Date: Fri, 21 Nov 2025 10:43:45 -0500 [thread overview]
Message-ID: <aSCIsezINmeijAxB@lizhi-Precision-Tower-5810> (raw)
In-Reply-To: <20251114133738.1762-4-laurentiumihalcea111@gmail.com>
On Fri, Nov 14, 2025 at 05:37:35AM -0800, Laurentiu Mihalcea wrote:
> From: Laurentiu Mihalcea <laurentiu.mihalcea@nxp.com>
>
> Switch to using the regmap API to allow performing register operations
> under the same lock. This is needed for cases such as i.MX8ULP's SIM LPAV
> where clock gating, reset control and MUX-ing is performed via the same
> register (i.e. SYSCTRL0) and different subsystem APIs.
>
> Signed-off-by: Laurentiu Mihalcea <laurentiu.mihalcea@nxp.com>
> ---
Reviewed-by: Frank Li <Frank.Li@nxp.com>
> drivers/reset/reset-imx8mp-audiomix.c | 92 +++++++++++++++++----------
> 1 file changed, 57 insertions(+), 35 deletions(-)
>
> diff --git a/drivers/reset/reset-imx8mp-audiomix.c b/drivers/reset/reset-imx8mp-audiomix.c
> index d993c294c548..35df9bd5f71a 100644
> --- a/drivers/reset/reset-imx8mp-audiomix.c
> +++ b/drivers/reset/reset-imx8mp-audiomix.c
> @@ -12,6 +12,7 @@
> #include <linux/module.h>
> #include <linux/of.h>
> #include <linux/of_address.h>
> +#include <linux/regmap.h>
> #include <linux/reset-controller.h>
>
> #define IMX8MP_AUDIOMIX_EARC_RESET_OFFSET 0x200
> @@ -43,8 +44,7 @@ static const struct imx8mp_reset_map reset_map[] = {
>
> struct imx8mp_audiomix_reset {
> struct reset_controller_dev rcdev;
> - spinlock_t lock; /* protect register read-modify-write cycle */
> - void __iomem *base;
> + struct regmap *regmap;
> };
>
> static struct imx8mp_audiomix_reset *to_imx8mp_audiomix_reset(struct reset_controller_dev *rcdev)
> @@ -56,26 +56,14 @@ static int imx8mp_audiomix_update(struct reset_controller_dev *rcdev,
> unsigned long id, bool assert)
> {
> struct imx8mp_audiomix_reset *priv = to_imx8mp_audiomix_reset(rcdev);
> - void __iomem *reg_addr = priv->base;
> - unsigned int mask, offset, active_low;
> - unsigned long reg, flags;
> + unsigned int mask, offset, active_low, val;
>
> mask = BIT(reset_map[id].bit);
> offset = reset_map[id].offset;
> active_low = reset_map[id].active_low;
> + val = (active_low ^ assert) << reset_map[id].bit;
>
> - spin_lock_irqsave(&priv->lock, flags);
> -
> - reg = readl(reg_addr + offset);
> - if (active_low ^ assert)
> - reg |= mask;
> - else
> - reg &= ~mask;
> - writel(reg, reg_addr + offset);
> -
> - spin_unlock_irqrestore(&priv->lock, flags);
> -
> - return 0;
> + return regmap_update_bits(priv->regmap, offset, mask, val);
> }
>
> static int imx8mp_audiomix_reset_assert(struct reset_controller_dev *rcdev,
> @@ -95,6 +83,52 @@ static const struct reset_control_ops imx8mp_audiomix_reset_ops = {
> .deassert = imx8mp_audiomix_reset_deassert,
> };
>
> +static const struct regmap_config regmap_config = {
> + .reg_bits = 32,
> + .val_bits = 32,
> + .reg_stride = 4,
> +};
> +
> +/* assumption: registered only if not using parent regmap */
> +static void imx8mp_audiomix_reset_iounmap(void *data)
> +{
> + void __iomem *base = (void __iomem *)data;
> +
> + iounmap(base);
> +}
> +
> +static int imx8mp_audiomix_reset_get_regmap(struct imx8mp_audiomix_reset *priv)
> +{
> + void __iomem *base;
> + struct device *dev;
> + int ret;
> +
> + dev = priv->rcdev.dev;
> +
> + /* try to use the parent's regmap */
> + priv->regmap = dev_get_regmap(dev->parent, NULL);
> + if (priv->regmap)
> + return 0;
> +
> + /* ... if that's not possible then initialize the regmap right now */
> + base = of_iomap(dev->parent->of_node, 0);
> + if (!base)
> + return dev_err_probe(dev, -ENOMEM, "failed to iomap address space\n");
> +
> + ret = devm_add_action_or_reset(dev,
> + imx8mp_audiomix_reset_iounmap,
> + (void __force *)base);
> + if (ret)
> + return dev_err_probe(dev, ret, "failed to register action\n");
> +
> + priv->regmap = devm_regmap_init_mmio(dev, base, ®map_config);
> + if (IS_ERR(priv->regmap))
> + return dev_err_probe(dev, PTR_ERR(priv->regmap),
> + "failed to initialize regmap\n");
> +
> + return 0;
> +}
> +
> static int imx8mp_audiomix_reset_probe(struct auxiliary_device *adev,
> const struct auxiliary_device_id *id)
> {
> @@ -106,36 +140,25 @@ static int imx8mp_audiomix_reset_probe(struct auxiliary_device *adev,
> if (!priv)
> return -ENOMEM;
>
> - spin_lock_init(&priv->lock);
> -
> priv->rcdev.owner = THIS_MODULE;
> priv->rcdev.nr_resets = ARRAY_SIZE(reset_map);
> priv->rcdev.ops = &imx8mp_audiomix_reset_ops;
> priv->rcdev.of_node = dev->parent->of_node;
> priv->rcdev.dev = dev;
> priv->rcdev.of_reset_n_cells = 1;
> - priv->base = of_iomap(dev->parent->of_node, 0);
> - if (!priv->base)
> - return -ENOMEM;
>
> dev_set_drvdata(dev, priv);
>
> + ret = imx8mp_audiomix_reset_get_regmap(priv);
> + if (ret)
> + return dev_err_probe(dev, ret, "failed to get regmap\n");
> +
> ret = devm_reset_controller_register(dev, &priv->rcdev);
> if (ret)
> - goto out_unmap;
> + return dev_err_probe(dev, ret,
> + "failed to register reset controller\n");
>
> return 0;
> -
> -out_unmap:
> - iounmap(priv->base);
> - return ret;
> -}
> -
> -static void imx8mp_audiomix_reset_remove(struct auxiliary_device *adev)
> -{
> - struct imx8mp_audiomix_reset *priv = dev_get_drvdata(&adev->dev);
> -
> - iounmap(priv->base);
> }
>
> static const struct auxiliary_device_id imx8mp_audiomix_reset_ids[] = {
> @@ -148,7 +171,6 @@ MODULE_DEVICE_TABLE(auxiliary, imx8mp_audiomix_reset_ids);
>
> static struct auxiliary_driver imx8mp_audiomix_reset_driver = {
> .probe = imx8mp_audiomix_reset_probe,
> - .remove = imx8mp_audiomix_reset_remove,
> .id_table = imx8mp_audiomix_reset_ids,
> };
>
> --
> 2.43.0
>
next prev parent reply other threads:[~2025-11-21 15:43 UTC|newest]
Thread overview: 21+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-11-14 13:37 [PATCH v5 0/6] Add support for i.MX8ULP's SIM LPAV Laurentiu Mihalcea
2025-11-14 13:37 ` [PATCH v5 1/6] reset: imx8mp-audiomix: Drop unneeded macros Laurentiu Mihalcea
2025-11-14 15:48 ` Philipp Zabel
2025-11-14 13:37 ` [PATCH v5 2/6] reset: imx8mp-audiomix: Replace mask with bit index Laurentiu Mihalcea
2025-11-14 15:48 ` Philipp Zabel
2025-11-21 15:38 ` Frank Li
2025-11-24 9:28 ` Laurentiu Mihalcea
2025-11-24 15:41 ` Frank Li
2025-11-25 9:59 ` Laurentiu Mihalcea
2025-11-25 10:40 ` Philipp Zabel
2025-11-25 23:34 ` Laurentiu Mihalcea
2025-11-14 13:37 ` [PATCH v5 3/6] reset: imx8mp-audiomix: Switch to using regmap API Laurentiu Mihalcea
2025-11-14 15:49 ` Philipp Zabel
2025-11-21 15:43 ` Frank Li [this message]
2025-11-14 13:37 ` [PATCH v5 4/6] reset: imx8mp-audiomix: Extend the driver usage Laurentiu Mihalcea
2025-11-14 16:02 ` Philipp Zabel
2025-11-21 9:29 ` Laurentiu Mihalcea
2025-11-21 15:18 ` Philipp Zabel
2025-11-14 13:37 ` [PATCH v5 5/6] reset: imx8mp-audiomix: Support i.MX8ULP SIM LPAV Laurentiu Mihalcea
2025-11-14 16:09 ` Philipp Zabel
2025-11-14 13:37 ` [PATCH v5 6/6] arm64: dts: imx8ulp: add sim lpav node Laurentiu Mihalcea
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=aSCIsezINmeijAxB@lizhi-Precision-Tower-5810 \
--to=frank.li@nxp.com \
--cc=conor+dt@kernel.org \
--cc=daniel.baluta@nxp.com \
--cc=devicetree@vger.kernel.org \
--cc=festevam@gmail.com \
--cc=imx@lists.linux.dev \
--cc=kernel@pengutronix.de \
--cc=krzk+dt@kernel.org \
--cc=laurentiumihalcea111@gmail.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=p.zabel@pengutronix.de \
--cc=shawnguo@kernel.org \
--cc=shengjiu.wang@nxp.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).