Re: [PATCH 08/11] ARM: dts: qcom: sdx55-t55: Enable PCIe RC support

[Konrad Dybcio <konrad.dybcio@linaro.org>]

On 22.02.2023 16:32, Manivannan Sadhasivam wrote:
> Enable PCIe RC support on Thundercomm T55 board.
> 
> Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
> ---
>  arch/arm/boot/dts/qcom-sdx55-t55.dts | 42 ++++++++++++++++++++++++++++
>  1 file changed, 42 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/qcom-sdx55-t55.dts b/arch/arm/boot/dts/qcom-sdx55-t55.dts
> index 7ed8feb99afb..fb5b9264077c 100644
> --- a/arch/arm/boot/dts/qcom-sdx55-t55.dts
> +++ b/arch/arm/boot/dts/qcom-sdx55-t55.dts
> @@ -242,6 +242,23 @@ &ipa {
>  	memory-region = <&ipa_fw_mem>;
>  };
>  
> +&pcie_phy {
> +	status = "okay";
'status' should go last. Since you're introducing new nodes,
changing the order in the existing ones would be appreciated.

> +
> +	vdda-phy-supply = <&vreg_l1e_bb_1p2>;
> +	vdda-pll-supply = <&vreg_l4e_bb_0p875>;
> +};
> +
> +&pcie_rc {
> +	status = "okay";
> +
> +	perst-gpios = <&tlmm 57 GPIO_ACTIVE_LOW>;
> +	wake-gpios = <&tlmm 53 GPIO_ACTIVE_HIGH>;
> +
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&pcie_default>;
property-
property-names

Konrad
> +};
> +
>  &qpic_bam {
>  	status = "ok";
>  };
> @@ -265,6 +282,31 @@ &remoteproc_mpss {
>  	memory-region = <&mpss_adsp_mem>;
>  };
>  
> +&tlmm {
> +	pcie_default: pcie-default-state {
> +		clkreq-pins {
> +			pins = "gpio56";
> +			function = "pcie_clkreq";
> +			drive-strength = <2>;
> +			bias-pull-up;
> +		};
> +
> +		perst-pins {
> +			pins = "gpio57";
> +			function = "gpio";
> +			drive-strength = <2>;
> +			bias-pull-down;
> +		};
> +
> +		wake-pins {
> +		       pins = "gpio53";
> +		       function = "gpio";
> +		       drive-strength = <2>;
> +		       bias-pull-up;
> +	       };
> +	};
> +};
> +
>  &usb_hsphy {
>  	status = "okay";
>  	vdda-pll-supply = <&vreg_l4e_bb_0p875>;