Re: [PATCH v9 5/6] iio: adc: ltc2378: Add support for LTC2338-18

[Marcelo Schmitt <marcelo.schmitt1@gmail.com>]

Hi Andy,

On 08/10, Andy Shevchenko wrote:
> On Mon, Jul 27, 2026 at 06:31:58PM -0300, Marcelo Schmitt wrote:
> > LTC2338-18 is similar to LTC2378-18, differentiating from the already
> > supported part mainly on the embedment of an internal voltage reference and
> > addition of a resistor divider network connected to the input signal path.
> > Extend the device driver, handling the internal reference and input signal
> > attenuation, enabling it to also support LTC2338-18.
> 
> ...
> 
> > +static int ltc2378_refin_setup(struct device *dev, struct ltc2378_state *st)
> > +{
> > +	int ret;
> > +
> > +	/*
> > +	 * The internal reference buffer amplifies both the internal reference
> > +	 * and REFIN by a factor of 2.
> > +	 */
> > +	ret = devm_regulator_get_enable_read_voltage(dev, "refin");
> > +	if (ret == -ENODEV) { /* refin is optional */
> > +		st->ref_uV = st->info->internal_ref_uV * 2;
> > +		return 0;
> > +	}
> > +
> > +	if (ret < 0)
> > +		return dev_err_probe(dev, ret, "failed to read refin regulator\n");
> > +
> > +	st->ref_uV = ret * 2;
> > +
> > +	return 0;
> 
> I'm not sure about others' preferences, but I would do it as if-else-if and
> remove dup return 0.
> 
> 	if (ret == -ENODEV) /* refin is optional */
> 		st->ref_uV = st->info->internal_ref_uV * 2;
> 	else if (ret < 0)
> 		return dev_err_probe(dev, ret, "failed to read refin regulator\n");
> 	else
> 		st->ref_uV = ret * 2;
> 
> 	return 0;
> 
> It also makes code shorter (in amount of LoC).

This has already been applied to IIO testing. I do send another version of this
specific patch if that's okay.

With Best Regards,
Marcelo