Re: [PATCH v2 3/4] arm64: dts: imx8mm: add the pcie phy support

[Lucas Stach <l.stach@pengutronix.de>]

Am Sonntag, dem 26.09.2021 um 15:39 +0800 schrieb Richard Zhu:
> Add the PCIe PHY support on iMX8MM platforms.
> 
> Signed-off-by: Richard Zhu <hongxing.zhu@nxp.com>
> ---
>  arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi |  4 ++++
>  arch/arm64/boot/dts/freescale/imx8mm.dtsi     | 12 ++++++++++++

This should be split into 2 patches: one for the SoC and one for the
EVK board.

>  2 files changed, 16 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> index e033d0257b5a..e7f398433486 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> +++ b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> @@ -289,6 +289,10 @@ pca6416: gpio@20 {
>  	};
>  };
>  
> +&pcie_phy {
> +	status = "okay";
> +};
> +
>  &sai3 {
>  	pinctrl-names = "default";
>  	pinctrl-0 = <&pinctrl_sai3>;
> diff --git a/arch/arm64/boot/dts/freescale/imx8mm.dtsi b/arch/arm64/boot/dts/freescale/imx8mm.dtsi
> index e7648c3b8390..de231d531ba4 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mm.dtsi
> +++ b/arch/arm64/boot/dts/freescale/imx8mm.dtsi
> @@ -998,6 +998,18 @@ usbmisc2: usbmisc@32e50200 {
>  				reg = <0x32e50200 0x200>;
>  			};
>  
> +			pcie_phy: pcie-phy@32f00000 {
> +				compatible = "fsl,imx8mm-pcie-phy";
> +				reg = <0x32f00000 0x10000>;
> +				clocks = <&clk IMX8MM_CLK_PCIE1_PHY>;
> +				clock-names = "phy";
> +				assigned-clocks = <&clk IMX8MM_CLK_PCIE1_PHY>;
> +				assigned-clock-rates = <100000000>;
> +				assigned-clock-parents = <&clk IMX8MM_SYS_PLL2_100M>;
> +				#phy-cells = <0>;
> +				fsl,refclk-pad-mode = <1>;

Move this to the board DT, as the pad mode is a board level decision.
Also use the enum instead of raw value.

> +				status = "disabled";
> +			};
>  		};
>  
>  		dma_apbh: dma-controller@33000000 {