Re: [net-next,PATCH v6 7/8] net: stmmac: dwmac-stm32: Mask support for PMCR configuration

[Marek Vasut <marex@denx.de>]

On 6/10/24 3:49 PM, Christophe ROULLIER wrote:
> 
> On 6/10/24 15:43, Marek Vasut wrote:
>> On 6/10/24 1:45 PM, Christophe ROULLIER wrote:
>>>
>>> On 6/10/24 12:39, Marek Vasut wrote:
>>>> On 6/10/24 9:14 AM, Christophe Roullier wrote:
>>>>
>>>> [...]
>>>>
>>>>>   static int stm32mp1_set_mode(struct plat_stmmacenet_data *plat_dat)
>>>>> @@ -303,7 +307,7 @@ static int stm32mcu_set_mode(struct 
>>>>> plat_stmmacenet_data *plat_dat)
>>>>>       dev_dbg(dwmac->dev, "Mode %s", 
>>>>> phy_modes(plat_dat->mac_interface));
>>>>>         return regmap_update_bits(dwmac->regmap, reg,
>>>>> -                 dwmac->ops->syscfg_eth_mask, val << 23);
>>>>> +                 SYSCFG_MCU_ETH_MASK, val << 23);
>>>>>   }
>>>>>     static void stm32_dwmac_clk_disable(struct stm32_dwmac *dwmac, 
>>>>> bool suspend)
>>>>> @@ -348,8 +352,15 @@ static int stm32_dwmac_parse_data(struct 
>>>>> stm32_dwmac *dwmac,
>>>>>           return PTR_ERR(dwmac->regmap);
>>>>>         err = of_property_read_u32_index(np, "st,syscon", 1, 
>>>>> &dwmac->mode_reg);
>>>>> -    if (err)
>>>>> +    if (err) {
>>>>>           dev_err(dev, "Can't get sysconfig mode offset (%d)\n", err);
>>>>> +        return err;
>>>>> +    }
>>>>> +
>>>>> +    dwmac->mode_mask = SYSCFG_MP1_ETH_MASK;
>>>>> +    err = of_property_read_u32_index(np, "st,syscon", 2, 
>>>>> &dwmac->mode_mask);
>>>>> +    if (err)
>>>>> +        dev_dbg(dev, "Warning sysconfig register mask not set\n");
>>>>
>>>> Isn't this an error , so dev_err() ?
>>> No, it is only "warning" information, for MP1 the mask is not needed 
>>> (and for backward compatibility is not planned to put mask parameter 
>>> mandatory)
>>
>> Should this be an error for anything newer than MP15 then ?
> For MP25, no need of mask, so for moment it is specific to MP13.

Make this a warning for MP15, error for MP13, do not check st,syscon 
presence for MP2 at all. Would that work ?