Re: [RFC PATCH v2 net-next 13/15] dt-bindings: lynx-pcs: add properties for backplane mode

[Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>]

On 23/09/2023 15:49, Vladimir Oltean wrote:
> When the Lynx PCS is deployed on a copper backplane link, it must be
> prepared to handle clause 73 autoneg and clause 72 link training, which
> it can do using a dedicated AN/LT block. The latter doesn't need to be
> described in the device tree, because it is discoverable from the SerDes
> lanes.
> 
> The media type that is deployed on the link is not discoverable though,
> so the introduction of a fsl,backplane-mode boolean property appears
> necessary to determine whether the AN/LT block should be employed, or
> left bypassed.
> 
> Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com>
> ---
> v1->v2: patch is new
> 
>  .../devicetree/bindings/net/pcs/fsl,lynx-pcs.yaml | 15 ++++++++++++++-
>  1 file changed, 14 insertions(+), 1 deletion(-)
> 
> diff --git a/Documentation/devicetree/bindings/net/pcs/fsl,lynx-pcs.yaml b/Documentation/devicetree/bindings/net/pcs/fsl,lynx-pcs.yaml
> index fbedf696c555..40fbcd80ee2a 100644
> --- a/Documentation/devicetree/bindings/net/pcs/fsl,lynx-pcs.yaml
> +++ b/Documentation/devicetree/bindings/net/pcs/fsl,lynx-pcs.yaml
> @@ -16,11 +16,24 @@ description: |
>  
>  properties:
>    compatible:
> -    const: fsl,lynx-pcs
> +    enum:
> +      - fsl,lx2160a-lynx-pcs
> +      - fsl,lynx-pcs
>  
>    reg:
>      maxItems: 1
>  
> +  phys:
> +    maxItems: 4
> +    description:
> +      phandle for the SerDes lanes that act as PMA/PMD layer when the PCS is
> +      part of a copper backplane PHY.
> +
> +  fsl,backplane-mode:
> +    $ref: /schemas/types.yaml#/definitions/flag
> +    description:
> +      Indicates that the PCS is deployed over a copper backplane link.
> +

Please extend also existing example. If these do not apply to lynx-pcs,
then they should be disallowed in allOf:if:then.

Best regards,
Krzysztof