Re: [RFC PATCH 01/10] dt-bindings: thermal: tsens: support per-sensor calibration cells

[Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>]

On 10/09/2022 14:46, Dmitry Baryshkov wrote:
> Allow specifing the exact calibration mode and calibration data as nvmem
> cells, rather than specifying just a single calibration data blob.
> 
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
> ---
>  .../bindings/thermal/qcom-tsens.yaml          | 64 ++++++++++++++++---
>  1 file changed, 54 insertions(+), 10 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/thermal/qcom-tsens.yaml b/Documentation/devicetree/bindings/thermal/qcom-tsens.yaml
> index 038d81338fcf..b813f6f19c1d 100644
> --- a/Documentation/devicetree/bindings/thermal/qcom-tsens.yaml
> +++ b/Documentation/devicetree/bindings/thermal/qcom-tsens.yaml
> @@ -77,18 +77,62 @@ properties:
>        - const: critical
>  
>    nvmem-cells:
> -    minItems: 1
> -    maxItems: 2
> -    description:
> -      Reference to an nvmem node for the calibration data
> +    oneOf:
> +      - minItems: 1
> +        maxItems: 2
> +        description:
> +          Reference to an nvmem node for the calibration data
> +      - minItems: 5
> +        maxItems: 35
> +        description: |
> +          Reference to an nvmem cells for the calibration mode, two calibration

s/an nvmem/nvmem/

Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>


Best regards,
Krzysztof