Re: [PATCH 0/2] arm64: dts: renesas: Add SD/OE pin properties

[Sean Anderson <sean.anderson@linux.dev>]

On 9/26/24 14:09, Sean Anderson wrote:
> Linux can configure almost every part of this clock generator without
> relying on the OTP settings. However, the correct configuration for the
> SD/OE pin cannot be determined automatically. Therefore, add the
> appropriate properties to configure this pin.
> 
> I have CC'd some people who appear to have access to the following
> boards which use the versaclock5:
> 
> - Salvator-X
> - HiHope RZ/G2[MN] Main Board
> - Beacon Embedded Works RZ/G2N Development Kit
> 
> as I could not find schematics for these boards. You can help me out by
> (pick one):
> 
> - Run the following command and send me the output:
> 
>     $ grep 10: /sys/kernel/debug/regmap/*-006a/registers
> 
> - Measure the voltage on the SD/OE pin on a functioning board.
> - Inspect (or send me) the schematic to determine the state of the SD/OE
>   pin during normal operation.
> 
> My suspicion is that all of these boards use the same configuration
> (SD/OE pin tied high) owing to their common design heritage. Thanks in
> advance.

+CC the people I meant to CC in the first place