Re: [PATCH RFC 1/7] dt-bindings: connector: usb-connector: add a gpio used to determine the Type-C port plug orientation

[Neil Armstrong <neil.armstrong@linaro.org>]

On 03/06/2023 22:22, Dmitry Baryshkov wrote:
> On 01/06/2023 17:07, Neil Armstrong wrote:
>> On some platforms, the Type-C plug orientation is given on a GPIO line.
>>
>> Document this optional Type-C connector property, and take the
>> assumption an active level represents an inverted/flipped orientation.
>>
>> Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org>
>> ---
>>   Documentation/devicetree/bindings/connector/usb-connector.yaml | 5 +++++
>>   1 file changed, 5 insertions(+)
>>
>> diff --git a/Documentation/devicetree/bindings/connector/usb-connector.yaml b/Documentation/devicetree/bindings/connector/usb-connector.yaml
>> index ae515651fc6b..c3884eed6ba4 100644
>> --- a/Documentation/devicetree/bindings/connector/usb-connector.yaml
>> +++ b/Documentation/devicetree/bindings/connector/usb-connector.yaml
>> @@ -114,6 +114,11 @@ properties:
>>       description: Set this property if the Type-C connector has no power delivery support.
>>       type: boolean
>> +  orientation-gpios:
>> +    description: An input gpio for Type-C connector orientation, used to detect orientation
>> +      of the Type-C connector. GPIO active level means "CC2" or Reversed/Flipped orientation.
>> +    maxItems: 1
> 
> Should this be a property of the connector or of the parent device node? I mean, unlike usb-b-connector (where ID and Vbus can be simple GPIOs nearly directly connected to the pins of the connector) for the USB-C the orientation is not a connector's GPIO, but rather some additional not elementary logic.

I don't see the issue, orientation is a property of the connector itself,
even if it's provided by another ic.

Neil

> 
>> +
>>     # The following are optional properties for "usb-c-connector" with power
>>     # delivery support.
>>     source-pdos:
>>
>