Re: [PATCH v3 4/4] clk: bcm: Add BCM63268 timer clock and reset driver

[Florian Fainelli <f.fainelli@gmail.com>]

On 3/21/23 16:23, Stephen Boyd wrote:
> Quoting Florian Fainelli (2023-03-21 16:09:54)
>> On 3/21/23 16:06, Stephen Boyd wrote:
>>> Quoting Florian Fainelli (2023-03-21 16:00:29)
>>>>
>>>> These SoCs are big-endian, require native endian register access and
>>>> have no posted writes within their bus logic (UBUS) and require no
>>>> barriers, hence the use of __raw_readl() and __raw_writel() is adequate.
>>>>
>>>
>>> Use ioread32be() then?
>>
>> BCM63xx drivers tend to use __raw_{read,write}l for consistency and to
>> make it clear that no barriers, no endian swapping is necessary, I would
>> prefer to remain consistent with that convention.
> 
> Ok.
> 
> Is the clk device big-endian? Or the CPU is big-endian? SoC being
> big-endian sounds like the devices in the SoC are big-endian. I hope we
> never plop this device down with a CPU that's litle-endian.

The CPU is big endian and the peripheral and bus to access the 
peripheral are native endian, so also big endian in that case.

The newer SoCs are ARM-based and are little endian, but we already have 
a clock driver for those.
-- 
Florian