RE: [PATCH v2 3/3] dt-bindings: phy: realtek: Add the doc about the Realtek SoC USB 2.0/3.0 PHY

["Stanley Chang[昌育德]" <stanley_chang@realtek.com>]

Hi Krzysztof,

> >
> > Most of the properties are about the phy parameters.
> > Is the phy parameter data suitable to be placed in DTS?
> > I referenced other phy drivers.
> > These parameters should not be defined in dts.
> > I would move the parameters to the driver.
> 
> If these can be in the driver, why would ever they be in DTS in the first place?
> 
Our platforms have 3 xhci controllers which map to 3 different phy ports.
And the three phy ports use the same driver, but the parameters are different.
So I put the parameter settings in DTS, we have 3 usb-phy nodes representing 3 phy ports.
Also, some parameters have to be adjusted for different boards.
Therefore, it is more applicable in DTS than in driver.

> >>> +  realtek,usb:
> >>> +    description: The phandler of realtek dwc3 node
> >>
> >> "phandler"? Except obvious typo, drop "The phandler of" and describe
> >> what is it for.
> >
> > realtek,usb is a phandle of syscon used to control realtek dwc3 register.
> 
> Then no, phy should not control dwc3.

OK I know it doesn't make sense.
We want to disable phy suspend from mac layer.
I will try other method.

> >
> >>> +    $ref: /schemas/types.yaml#/definitions/phandle
> >>
> >> Anyway, it shouldn't be here. No, no.
> >
> > Can I use it for phandle of syscon?
> 
> PHY getting phandle to block using this PHY? Looks wrong. Why would PHY
> need to poke IP block register?
> 

OK. I know it doesn't make sense.