Re: [PATCH v8.1, 6/7] arm64: dts: mt8195: Add thermal zone

[Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>]

On 04/08/2022 15:09, bchihi@baylibre.com wrote:
> From: Tinghan Shen <tinghan.shen@mediatek.com>
> 
> This adds the thermal zone for the mt8195.
> 
> Signed-off-by: Tinghan Shen <tinghan.shen@mediatek.com>
> Signed-off-by: Ben Tseng <ben.tseng@mediatek.com>
> Signed-off-by: Alexandre Bailon <abailon@baylibre.com>
> Signed-off-by: Balsam CHIHI <bchihi@baylibre.com>
> ---
>  arch/arm64/boot/dts/mediatek/mt8195.dtsi | 111 +++++++++++++++++++++++
>  1 file changed, 111 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/mediatek/mt8195.dtsi b/arch/arm64/boot/dts/mediatek/mt8195.dtsi
> index cbd0401968a2..5890e688eebe 100644
> --- a/arch/arm64/boot/dts/mediatek/mt8195.dtsi
> +++ b/arch/arm64/boot/dts/mediatek/mt8195.dtsi
> @@ -10,6 +10,7 @@
>  #include <dt-bindings/interrupt-controller/irq.h>
>  #include <dt-bindings/phy/phy.h>
>  #include <dt-bindings/pinctrl/mt8195-pinfunc.h>
> +#include <dt-bindings/reset/mt8195-resets.h>
>  
>  / {
>  	compatible = "mediatek,mt8195";
> @@ -452,6 +453,28 @@ spi0: spi@1100a000 {
>  			status = "disabled";
>  		};
>  
> +		lvts_ap: thermal-sensor@1100b000 {
> +			compatible = "mediatek,mt8195-lvts-ap";
> +			#thermal-sensor-cells = <1>;
> +			reg = <0 0x1100b000 0 0x1000>;
> +			interrupts = <GIC_SPI 169 IRQ_TYPE_LEVEL_HIGH 0>;
> +			clocks = <&infracfg_ao CLK_INFRA_AO_THERM>;
> +			resets = <&infracfg_ao MT8195_INFRA_RST0_THERM_CTRL_SWRST>;
> +			nvmem-cells = <&lvts_efuse_data1 &lvts_efuse_data2>;
> +			nvmem-cell-names = "lvts_calib_data1", "lvts_calib_data2";
> +		};
> +
> +		lvts_mcu: thermal-sensor@11278000 {
> +			compatible = "mediatek,mt8195-lvts-mcu";
> +			#thermal-sensor-cells = <1>;
> +			reg = <0 0x11278000 0 0x1000>;
> +			interrupts = <GIC_SPI 170 IRQ_TYPE_LEVEL_HIGH 0>;
> +			clocks = <&infracfg_ao CLK_INFRA_AO_THERM>;
> +			resets = <&infracfg_ao MT8195_INFRA_RST4_THERM_CTRL_MCU_SWRST>;
> +			nvmem-cells = <&lvts_efuse_data1 &lvts_efuse_data2>;
> +			nvmem-cell-names = "lvts_calib_data1", "lvts_calib_data2";
> +		};
> +
>  		spi1: spi@11010000 {
>  			compatible = "mediatek,mt8195-spi",
>  				     "mediatek,mt6765-spi";
> @@ -1106,4 +1129,92 @@ vencsys_core1: clock-controller@1b000000 {
>  			#clock-cells = <1>;
>  		};
>  	};
> +
> +	thermal_zones: thermal-zones {
> +		cpu-big1-thermal {

Does this pass dtbs_check?

Best regards,
Krzysztof