[PATCH 0/3] arm64: zynqmp: Add support for EBDEE EdgeBoard FZ3A

[Pufan Jin <2254650260@qq.com>]

The EBDEE EdgeBoard FZ3A is a development board built around the MYIR
MYS-CZU3EG SoM, based on the Xilinx Zynq UltraScale+ XCZU3EG.

This series adds the EBDEE vendor prefix, documents the board compatible,
and adds a device tree for the board's PS peripherals:

  - UART1 debug console
  - eMMC and microSD card
  - GEM3 Ethernet
  - I2C0 and I2C1
  - QSPI NOR flash
  - PCIe
  - USB 3.0 host
  - DisplayPort output

The Paddle-Mobile FPGA accelerator is not included. Its PL description
depends on vendor-specific IP and an out-of-tree driver.

Tested on EBDEE FZ3A hardware with Linux 7.3.0-rc5: the board boots from
the SD card into userspace over the serial console, and all enabled board
functions work as expected.

The base DTB passes CHECK_DTBS=y, and the Xilinx SoC binding passes
dt_binding_check.

Pufan Jin (3):
  dt-bindings: Add EBDEE vendor prefix
  dt-bindings: soc: xilinx: Add EBDEE EdgeBoard FZ3A
  arm64: zynqmp: Add EBDEE EdgeBoard FZ3A development board

 .../bindings/soc/xilinx/xilinx.yaml           |   1 +
 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 arch/arm64/boot/dts/xilinx/Makefile           |   1 +
 .../xilinx/zynqmp-ebdee-edgeboard-fz3a.dts    | 272 ++++++++++++++++++
 4 files changed, 276 insertions(+)
 create mode 100644 arch/arm64/boot/dts/xilinx/zynqmp-ebdee-edgeboard-fz3a.dts


base-commit: 72d3fcf802c45d00b300f25b848a93c3a2bd7c7e
-- 
2.55.0