[PATCH] ALSA: machine: update documentation

[anish kumar <yesanishhere@gmail.com>]

1. Added clocking details.
2. Updated ways to register the dai's
3. Bit more detail about card registration details.

Signed-off-by: anish kumar <yesanishhere@gmail.com>
---
 Documentation/sound/soc/machine.rst | 30 +++++++++++++++++++++++++++--
 1 file changed, 28 insertions(+), 2 deletions(-)

diff --git a/Documentation/sound/soc/machine.rst b/Documentation/sound/soc/machine.rst
index 515c9444deaf..af7bad7ba134 100644
--- a/Documentation/sound/soc/machine.rst
+++ b/Documentation/sound/soc/machine.rst
@@ -71,6 +71,18 @@ struct snd_soc_dai_link is used to set up each DAI in your machine. e.g.
 	.ops = &corgi_ops,
   };
 
+In the above struct, dai’s are registered using names but you can pass
+either dai name or device tree node but not both. Also, names used here
+for cpu/codec/platform dais should be globally unique.
+
+Additionaly below example macro can be used to register cpu, codec and
+platform dai.
+
+SND_SOC_DAILINK_DEFS(wm2200_cpu_dsp,
+	DAILINK_COMP_ARRAY(COMP_CPU("samsung-i2s.0")),
+	DAILINK_COMP_ARRAY(COMP_CODEC("spi0.0", "wm0010-sdi1")),
+	DAILINK_COMP_ARRAY(COMP_PLATFORM("samsung-i2s.0")));
+
 struct snd_soc_card then sets up the machine with its DAIs. e.g.
 ::
 
@@ -81,9 +93,13 @@ struct snd_soc_card then sets up the machine with its DAIs. e.g.
 	.num_links = 1,
   };
 
+Following this, ``devm_snd_soc_register_card`` can be used to register
+the sound card. During the registration, the individual components
+such as the codec, CPU, and platform are probed. If all these components
+are successfully probed, the sound card gets registered.
 
 Machine Power Map
------------------
+---------------------------
 
 The machine driver can optionally extend the codec power map and to become an
 audio power map of the audio subsystem. This allows for automatic power up/down
@@ -92,6 +108,16 @@ sockets in the machine init function.
 
 
 Machine Controls
-----------------
+-----------------------
 
 Machine specific audio mixer controls can be added in the DAI init function.
+
+
+Clocking Controls:
+—-----------------
+
+As previously noted, clock configuration is handled within the machine driver.
+For details on the clock APIs that the machine driver can utilize for
+setup, please refer to Documentation/sound/soc/clocking.rst. However, the
+callback needs to be registered by the CPU/Codec/Platform drivers to configure
+the clocks that is needed for the corresponding device operation.
-- 
2.39.3 (Apple Git-146)