Linux Documentation
 help / color / mirror / Atom feed
From: Stoyan Bogdanov <sbogdanov@baylibre.com>
To: jbrunet@baylibre.com, linux@roeck-us.net, robh@kernel.org,
	krzk+dt@kernel.org, conor+dt@kernel.org, corbet@lwn.net,
	skhan@linuxfoundation.org
Cc: linux-hwmon@vger.kernel.org, devicetree@vger.kernel.org,
	linux-doc@vger.kernel.org, linux-kernel@vger.kernel.org,
	Stoyan Bogdanov <sbogdanov@baylibre.com>
Subject: [PATCH v4 4/4] hwmon: (pmbus/tps25990): Add TPS1689 support
Date: Fri, 22 May 2026 11:23:39 +0300	[thread overview]
Message-ID: <20260522082349.2749970-5-sbogdanov@baylibre.com> (raw)
In-Reply-To: <20260522082349.2749970-1-sbogdanov@baylibre.com>

Extend the existing TPS25990 driver to support the TPS1689 eFuse,
as both devices share the same command interface and functionality.

Update the documentation to include TPS1689 support.

Signed-off-by: Stoyan Bogdanov <sbogdanov@baylibre.com>
---
 Documentation/hwmon/tps25990.rst | 15 +++++---
 drivers/hwmon/pmbus/tps25990.c   | 66 +++++++++++++++++++++++++++++++-
 2 files changed, 74 insertions(+), 7 deletions(-)

diff --git a/Documentation/hwmon/tps25990.rst b/Documentation/hwmon/tps25990.rst
index 04faec780d26..e8bc9a550bda 100644
--- a/Documentation/hwmon/tps25990.rst
+++ b/Documentation/hwmon/tps25990.rst
@@ -9,26 +9,31 @@ Supported chips:
 
     Prefix: 'tps25990'
 
-  * Datasheet
+    Datasheet: Publicly available at Texas Instruments website: https://www.ti.com/lit/gpn/tps25990
 
-    Publicly available at Texas Instruments website: https://www.ti.com/lit/gpn/tps25990
+  * TI TPS1689
+
+    Prefix: 'tps1689'
+
+    Datasheet: Publicly available at Texas Instruments website: https://www.ti.com/lit/gpn/tps1689
 
 Author:
 
 	Jerome Brunet <jbrunet@baylibre.com>
+	Stoyan Bogdanov <sbogdanov@baylibre.com>
 
 Description
 -----------
 
-This driver implements support for TI TPS25990 eFuse.
+This driver implements support for TI TPS25990 and TI TPS1689 eFuse chips.
 This is an integrated, high-current circuit protection and power
 management device with PMBUS interface
 
-Device compliant with:
+Devices are compliant with:
 
 - PMBus rev 1.3 interface.
 
-Device supports direct format for reading input voltages,
+Devices supports direct format for reading input voltages,
 output voltage, input current, input power and temperature.
 
 Due to the specificities of the chip, all history reset attributes
diff --git a/drivers/hwmon/pmbus/tps25990.c b/drivers/hwmon/pmbus/tps25990.c
index 1e252844217b..720e134f1892 100644
--- a/drivers/hwmon/pmbus/tps25990.c
+++ b/drivers/hwmon/pmbus/tps25990.c
@@ -42,6 +42,7 @@
 					 PK_MIN_AVG_RST_MIN)
 
 enum chips {
+	tps1689,
 	tps25990,
 };
 
@@ -286,7 +287,6 @@ static int tps25990_write_word_data(struct i2c_client *client,
 		value = clamp_val(value, 0, 0xff);
 		ret = pmbus_write_word_data(client, page, reg, value);
 		break;
-
 	case PMBUS_VIN_OV_FAULT_LIMIT:
 		value = tps25990_data2reg_direct(client, TPS25990_VIN_OVF, value);
 		value = clamp_val(value, 0, 0xf);
@@ -376,6 +376,14 @@ static const struct regulator_desc tps25990_reg_desc[] = {
 #endif
 
 static struct tps25990_local_direct_value tps25990_local_info[] = {
+	[tps1689] = {
+		.m[TPS25990_VIN_OVF] = 3984,
+		.b[TPS25990_VIN_OVF] = -63750,
+		.R[TPS25990_VIN_OVF] = -3,
+		.m[TPS25990_IIN_OCF] = 7111,
+		.b[TPS25990_IIN_OCF] = -2133,
+		.R[TPS25990_IIN_OCF] = -2,
+	},
 	[tps25990] = {
 		.m[TPS25990_VIN_OVF] = 10163,
 		.b[TPS25990_VIN_OVF] = -30081,
@@ -387,6 +395,59 @@ static struct tps25990_local_direct_value tps25990_local_info[] = {
 };
 
 static struct pmbus_driver_info tps25990_base_info[] = {
+	[tps1689] = {
+		.pages = 1,
+		.format[PSC_VOLTAGE_IN] = direct,
+		.m[PSC_VOLTAGE_IN] = 1166,
+		.b[PSC_VOLTAGE_IN] = 0,
+		.R[PSC_VOLTAGE_IN] = -2,
+		.format[PSC_VOLTAGE_OUT] = direct,
+		.m[PSC_VOLTAGE_OUT] = 1166,
+		.b[PSC_VOLTAGE_OUT] = 0,
+		.R[PSC_VOLTAGE_OUT] = -2,
+		.format[PSC_TEMPERATURE] = direct,
+		.m[PSC_TEMPERATURE] = 140,
+		.b[PSC_TEMPERATURE] = 32103,
+		.R[PSC_TEMPERATURE] = -2,
+		/*
+		 * Current and Power measurement depends on the ohm value
+		 * of Rimon. m is multiplied by 1000 below to have an integer
+		 * and -3 is added to R to compensate.
+		 */
+		.format[PSC_CURRENT_IN] = direct,
+		.m[PSC_CURRENT_IN] = 9548,
+		.b[PSC_CURRENT_IN] = 0,
+		.R[PSC_CURRENT_IN] = -6,
+		.format[PSC_CURRENT_OUT] = direct,
+		.m[PSC_CURRENT_OUT] = 24347,
+		.b[PSC_CURRENT_OUT] = 0,
+		.R[PSC_CURRENT_OUT] = -3,
+		.format[PSC_POWER] = direct,
+		.m[PSC_POWER] = 2775,
+		.b[PSC_POWER] = 0,
+		.R[PSC_POWER] = -4,
+		.func[0] = (PMBUS_HAVE_VIN |
+			    PMBUS_HAVE_VOUT |
+			    PMBUS_HAVE_VMON |
+			    PMBUS_HAVE_IIN |
+			    PMBUS_HAVE_PIN |
+			    PMBUS_HAVE_TEMP |
+			    PMBUS_HAVE_STATUS_VOUT |
+			    PMBUS_HAVE_STATUS_IOUT |
+			    PMBUS_HAVE_STATUS_INPUT |
+			    PMBUS_HAVE_STATUS_TEMP |
+			    PMBUS_HAVE_SAMPLES),
+
+		.read_word_data = tps25990_read_word_data,
+		.write_word_data = tps25990_write_word_data,
+		.read_byte_data = tps25990_read_byte_data,
+		.write_byte_data = tps25990_write_byte_data,
+
+#if IS_ENABLED(CONFIG_SENSORS_TPS25990_REGULATOR)
+		.reg_desc = tps25990_reg_desc,
+		.num_regulators = ARRAY_SIZE(tps25990_reg_desc),
+#endif
+		},
 	[tps25990] = {
 		.pages = 1,
 		.format[PSC_VOLTAGE_IN] = direct,
@@ -429,7 +490,6 @@ static struct pmbus_driver_info tps25990_base_info[] = {
 		.write_word_data = tps25990_write_word_data,
 		.read_byte_data = tps25990_read_byte_data,
 		.write_byte_data = tps25990_write_byte_data,
-
 #if IS_ENABLED(CONFIG_SENSORS_TPS25990_REGULATOR)
 		.reg_desc = tps25990_reg_desc,
 		.num_regulators = ARRAY_SIZE(tps25990_reg_desc),
@@ -438,12 +498,14 @@ static struct pmbus_driver_info tps25990_base_info[] = {
 };
 
 static const struct i2c_device_id tps25990_i2c_id[] = {
+	{ "tps1689", tps1689 },
 	{ "tps25990", tps25990 },
 	{}
 };
 MODULE_DEVICE_TABLE(i2c, tps25990_i2c_id);
 
 static const struct of_device_id tps25990_of_match[] = {
+	{ .compatible = "ti,tps1689", .data = (void *)tps1689 },
 	{ .compatible = "ti,tps25990", .data = (void *)tps25990 },
 	{}
 };
-- 
2.43.0


      parent reply	other threads:[~2026-05-22  8:24 UTC|newest]

Thread overview: 7+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-05-22  8:23 [PATCH v4 0/4] Rework TPS25990 direct conversions and add TPS1689 support Stoyan Bogdanov
2026-05-22  8:23 ` [PATCH v4 1/4] hwmon: (pmbus) Add and export direct conversion calculation helpers Stoyan Bogdanov
2026-05-23 13:25   ` Guenter Roeck
2026-05-22  8:23 ` [PATCH v4 2/4] hwmon: (pmbus/tps25990): Rework TPS25990 direct conversion handling Stoyan Bogdanov
2026-05-23 14:17   ` Guenter Roeck
2026-05-22  8:23 ` [PATCH v4 3/4] dt-bindings: hwmon: pmbus/tps25990: Add TPS1689 Stoyan Bogdanov
2026-05-22  8:23 ` Stoyan Bogdanov [this message]

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20260522082349.2749970-5-sbogdanov@baylibre.com \
    --to=sbogdanov@baylibre.com \
    --cc=conor+dt@kernel.org \
    --cc=corbet@lwn.net \
    --cc=devicetree@vger.kernel.org \
    --cc=jbrunet@baylibre.com \
    --cc=krzk+dt@kernel.org \
    --cc=linux-doc@vger.kernel.org \
    --cc=linux-hwmon@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux@roeck-us.net \
    --cc=robh@kernel.org \
    --cc=skhan@linuxfoundation.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox