[RFC PATCH 26/27] Docs/admin-guide/mm/damon/usage: update for user_report report support

[SJ Park <sj@kernel.org>]

Update DAMON usage document for the newly added user_report type data
attribute report support.

Signed-off-by: SJ Park <sj@kernel.org>
---
 Documentation/admin-guide/mm/damon/usage.rst | 11 ++++++++++-
 1 file changed, 10 insertions(+), 1 deletion(-)

diff --git a/Documentation/admin-guide/mm/damon/usage.rst b/Documentation/admin-guide/mm/damon/usage.rst
index ce4e9e4c13276..4024dd4e92979 100644
--- a/Documentation/admin-guide/mm/damon/usage.rst
+++ b/Documentation/admin-guide/mm/damon/usage.rst
@@ -117,7 +117,7 @@ comma (",").
     │ │ ...
     │ reports/
     │ │ producers/nr_producers
-    │ │ │ 0/report_type,producer_state
+    │ │ │ 0/report_type,producer_state,addr_start,addr_end
     │ │ │ ...
 
 .. _sysfs_root:
@@ -767,6 +767,15 @@ Users can write below keywords for the producer to the file.
 
 - ``on``: Enable the producer.
 - ``off``: Disable the producer.
+- ``submit``: Generate and submit a new ``user_report`` type report, if
+  ``report_type`` is ``user_report``, and the producer is enabled.
+
+``addr_start`` and ``addr_end`` files are used only for ``user_report`` report
+type.  Those set the address range of memory to manually report .  Users can
+set the start and end address of the address range by writing the addresses to
+the files.  Note that it is open-end range (``[addr_start,addr_end)``) and
+therefore the end address is exclusive.  Reading the files shows the last
+successfully written input.
 
 .. _tracepoint:
 
-- 
2.47.3