From mboxrd@z Thu Jan 1 00:00:00 1970 From: Maxime Ripard Date: Fri, 12 Apr 2013 08:00:03 +0000 Subject: [PATCH 2/2] ARM: dts: cfa10036: Change the OLED display to SSD1306 Message-Id: <1365753603-4438-3-git-send-email-maxime.ripard@free-electrons.com> List-Id: References: <1365753603-4438-1-git-send-email-maxime.ripard@free-electrons.com> In-Reply-To: <1365753603-4438-1-git-send-email-maxime.ripard@free-electrons.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: linux-arm-kernel@lists.infradead.org The SSD1307 was used in an early prototype that will never get distributed. The final board now has a SSD1306 instead, that has its own power generation unit and thus doesn't need any PWM. The panel attached to it also changed. Signed-off-by: Maxime Ripard --- arch/arm/boot/dts/imx28-cfa10036.dts | 14 +++++--------- arch/arm/boot/dts/imx28-cfa10049.dts | 4 ++-- 2 files changed, 7 insertions(+), 11 deletions(-) diff --git a/arch/arm/boot/dts/imx28-cfa10036.dts b/arch/arm/boot/dts/imx28-cfa10036.dts index 1594694..40488f5a8 100644 --- a/arch/arm/boot/dts/imx28-cfa10036.dts +++ b/arch/arm/boot/dts/imx28-cfa10036.dts @@ -58,12 +58,6 @@ }; apbx@80040000 { - pwm: pwm@80064000 { - pinctrl-names = "default"; - pinctrl-0 = <&pwm4_pins_a>; - status = "okay"; - }; - duart: serial@80074000 { pinctrl-names = "default"; pinctrl-0 = <&duart_pins_b>; @@ -75,11 +69,13 @@ pinctrl-0 = <&i2c0_pins_b>; status = "okay"; - ssd1307: oled@3c { - compatible = "solomon,ssd1307fb-i2c"; + ssd1306: oled@3c { + compatible = "solomon,ssd1306fb-i2c"; reg = <0x3c>; - pwms = <&pwm 4 3000>; reset-gpios = <&gpio2 7 0>; + solomon,height = <32>; + solomon,width = <128>; + solomon,page-offset = <0>; }; }; }; diff --git a/arch/arm/boot/dts/imx28-cfa10049.dts b/arch/arm/boot/dts/imx28-cfa10049.dts index a0d3e9f..ded7784 100644 --- a/arch/arm/boot/dts/imx28-cfa10049.dts +++ b/arch/arm/boot/dts/imx28-cfa10049.dts @@ -132,8 +132,8 @@ apbx@80040000 { pwm: pwm@80064000 { - pinctrl-names = "default", "default"; - pinctrl-1 = <&pwm3_pins_b>; + pinctrl-names = "default"; + pinctrl-0 = <&pwm3_pins_b>; status = "okay"; }; -- 1.7.10.4