Re: [PATCH 3/3] staging: sm7xxfb: change return of sm7xx_vga_setup

[Dan Carpenter <dan.carpenter@oracle.com>]

On Mon, Mar 09, 2015 at 07:00:33PM +0530, Sudip Mukherjee wrote:
> On Mon, Mar 09, 2015 at 04:13:43PM +0300, Dan Carpenter wrote:
> > On Sun, Mar 08, 2015 at 11:10:11PM +0530, Sudip Mukherjee wrote:
> > > change return type of sm7xx_vga_setup() to void as we are not using
> > > the return type anywhere. if this function fails we fall back to the
> > > default configuration.
> > > 
> > > Signed-off-by: Sudip Mukherjee <sudip@vectorindia.org>
> > 
> > Reviewed-by: Dan Carpenter <dan.carpenter@oracle.com>
> > 
> > This patch is fine but if you wanted you could send a follow on which
> > set it to SCREEN_X_RES, SCREEN_Y_RES, SCREEN_BPP if there were no
> > options.  Then remove the "if (smtc_scr_info.lfb_width != 0) " condition
> > in smtcfb_pci_probe().
> 
> yes, i could have. But actually I am thinking to totally remove this function and use more conventional fb_get_mode() in its places. But if i do so then the boot parameters will change. Currently it is like vga=sm712fb:0x301 but if i change it to use fb_get_mode() then the boot parameters will change to vga=sm712fb:640x480@60-8 , and that is why I am hesitating. But it will be more conventional to what all framebuffer drivers follows.
> 

Hm...  That's a good question.

I suspect we should just go with fb_get_mode() and do it quickly.  This
driver is so new in the kernel that there are no users to get upset.

regards,
dan carpenter