[PATCH 2/4] fbdev/hyperv_fb: Remove firmware framebuffers with aperture helpers

[Thomas Zimmermann <tzimmermann@suse.de>]

Replace use of screen_info state with the correct interfaces from
the aperture helpers. The state is only for architecture and firmware
code. It is not guaranteed to contain valid data. Drivers are thus
not allowed to use it.

For removing conflicting firmware framebuffers, there are aperture
helpers. Hence replace screen_info with the correct functions that will
remove conflicting framebuffers for the hypervfb driver. For GEN1 PCI
devices, the driver reads the framebuffer base and size from the PCI
BAR, and uses the range for removing the firmware framebuffer. For
GEN2 VMBUS devices no range can be detected, so the driver clears all
firmware framebuffers.

Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>
---
 drivers/video/fbdev/hyperv_fb.c | 11 ++++++-----
 1 file changed, 6 insertions(+), 5 deletions(-)

diff --git a/drivers/video/fbdev/hyperv_fb.c b/drivers/video/fbdev/hyperv_fb.c
index a80939fe2ee6..76c956b9a321 100644
--- a/drivers/video/fbdev/hyperv_fb.c
+++ b/drivers/video/fbdev/hyperv_fb.c
@@ -975,7 +975,8 @@ static int hvfb_getmem(struct hv_device *hdev, struct fb_info *info)
 	struct pci_dev *pdev  = NULL;
 	void __iomem *fb_virt;
 	int gen2vm = efi_enabled(EFI_BOOT);
-	resource_size_t base, size;
+	resource_size_t base = 0;
+	resource_size_t size = 0;
 	phys_addr_t paddr;
 	int ret;
 
@@ -1010,9 +1011,6 @@ static int hvfb_getmem(struct hv_device *hdev, struct fb_info *info)
 			goto getmem_done;
 		}
 		pr_info("Unable to allocate enough contiguous physical memory on Gen 1 VM. Using MMIO instead.\n");
-	} else if (IS_ENABLED(CONFIG_SYSFB)) {
-		base = screen_info.lfb_base;
-		size = screen_info.lfb_size;
 	} else {
 		goto err1;
 	}
@@ -1056,7 +1054,10 @@ static int hvfb_getmem(struct hv_device *hdev, struct fb_info *info)
 	info->screen_size = dio_fb_size;
 
 getmem_done:
-	aperture_remove_conflicting_devices(base, size, KBUILD_MODNAME);
+	if (base && size)
+		aperture_remove_conflicting_devices(base, size, KBUILD_MODNAME);
+	else
+		aperture_remove_all_conflicting_devices(KBUILD_MODNAME);
 
 	if (!gen2vm) {
 		pci_dev_put(pdev);
-- 
2.43.0