Re: [PATCH v10 4/6] devicetree: Add new SKY81452 backlight binding

[Rob Herring <robherring2@gmail.com>]

On Fri, Jan 23, 2015 at 12:28 AM,  <gyungoh@gmail.com> wrote:
> From: Gyungoh Yoo <jack.yoo@skyworksinc.com>
>
> Signed-off-by: Gyungoh Yoo <jack.yoo@skyworksinc.com>
> Acked-by: Bryan Wu <cooloney@gmail.com>
> ---
> Changes v10:
> Nothing
>
> Changes v9:
> Nothing
>
> Changes v8:
> Renamed property names for backlight with vendor prefix
> Modified gpio-enable property to generic property for GPIO
> Made up the example for backlight DT
>
> Changes v7:
> Nothing
>
> Changes v6:
> Nothing
>
> Changes v5:
> Nothing
>
> Changes v4:
> Nothing
>
> Changes v3:
> Nothing
>
> Changes v2:
> Added reg attribute for I2C slave address

You did? Where is it?

>  .../video/backlight/sky81452-backlight.txt         | 29 ++++++++++++++++++++++
>  1 file changed, 29 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/video/backlight/sky81452-backlight.txt
>
> diff --git a/Documentation/devicetree/bindings/video/backlight/sky81452-backlight.txt b/Documentation/devicetree/bindings/video/backlight/sky81452-backlight.txt
> new file mode 100644
> index 0000000..8daebf5
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/video/backlight/sky81452-backlight.txt
> @@ -0,0 +1,29 @@
> +SKY81452-backlight bindings
> +
> +Required properties:
> +- compatible           : Must be "skyworks,sky81452-backlight"
> +
> +Optional properties:
> +- name                 : Name of backlight device. Default is 'lcd-backlight'.
> +- gpios                        : GPIO to use to EN pin.
> +                       See Documentation/devicetree/bindings/gpio/gpio.txt
> +- skyworks,en-channels : Enable mask for current sink channel 1 to 6.

Does led-sources property being added in 3.20 work for this?

> +- skyworks,ignore-pwm  : Ignore both PWM input
> +- skyworks,dpwm-mode   : Enable DPWM dimming mode, otherwise Analog dimming.
> +- skyworks,phase-shift : Enable phase shift mode
> +- skyworks,ovp-level   : Over-voltage protection level.
> +                       Should be between 14 or 28V.

Please append units (-volt)

> +- skyworks,short-detection-threshold   : It should be one of 4, 5, 6 and 7V.

Please append units (-volt)

> +- skyworks,current-limit       : It should be 2300mA or 2750mA.

Please append units (-mA)

> +
> +Example:
> +
> +       backlight {
> +               compatible = "skyworks,sky81452-backlight";
> +               name = "pwm-backlight";
> +               skyworks,en-channels = <0x3f>;
> +               skyworks,ignore-pwm;
> +               skyworks,phase-shift;
> +               skyworks,ovp-level = <20>;
> +               skyworks,current-limit = <2300>;
> +       };
> --
> 1.9.1
>