* [PATCH 5/5] fbdev: sh_mobile_hdmi: add support for 1080p modes
@ 2010-11-04 11:06 Guennadi Liakhovetski
0 siblings, 0 replies; only message in thread
From: Guennadi Liakhovetski @ 2010-11-04 11:06 UTC (permalink / raw)
To: linux-fbdev
Add support for 3 more preprogrammed video modes: 1080p at 24, 50, and 60Hz.
Signed-off-by: Guennadi Liakhovetski <g.liakhovetski@gmx.de>
---
drivers/video/sh_mobile_hdmi.c | 56 +++++++++++++++++++++++++---------------
1 files changed, 35 insertions(+), 21 deletions(-)
diff --git a/drivers/video/sh_mobile_hdmi.c b/drivers/video/sh_mobile_hdmi.c
index dadb632..af101bd 100644
--- a/drivers/video/sh_mobile_hdmi.c
+++ b/drivers/video/sh_mobile_hdmi.c
@@ -209,7 +209,7 @@ enum hotplug_state {
struct sh_hdmi {
void __iomem *base;
enum hotplug_state hp_state; /* hot-plug status */
- bool preprogrammed_mode; /* use a pre-programmed VIC or the external mode */
+ u8 preprogrammed_vic; /* use a pre-programmed VIC or the external mode */
u8 edid_block_addr;
u8 edid_segment_nr;
u8 edid_blocks;
@@ -345,7 +345,7 @@ static void sh_hdmi_external_video_param(struct sh_hdmi *hdmi)
hdmi_write(hdmi, var->vsync_len, HDMI_EXTERNAL_V_DURATION);
/* Set bit 0 of HDMI_EXTERNAL_VIDEO_PARAM_SETTINGS here for external mode */
- if (!hdmi->preprogrammed_mode)
+ if (!hdmi->preprogrammed_vic)
hdmi_write(hdmi, sync | 1 | (voffset << 4),
HDMI_EXTERNAL_VIDEO_PARAM_SETTINGS);
}
@@ -469,7 +469,18 @@ static void sh_hdmi_audio_config(struct sh_hdmi *hdmi)
*/
static void sh_hdmi_phy_config(struct sh_hdmi *hdmi)
{
- if (hdmi->var.pixclock < 30000) {
+ if (hdmi->var.pixclock < 10000) {
+ /* for 1080p8bit 148MHz */
+ hdmi_write(hdmi, 0x1d, HDMI_SLIPHDMIT_PARAM_SETTINGS_1);
+ hdmi_write(hdmi, 0x00, HDMI_SLIPHDMIT_PARAM_SETTINGS_2);
+ hdmi_write(hdmi, 0x00, HDMI_SLIPHDMIT_PARAM_SETTINGS_3);
+ hdmi_write(hdmi, 0x4c, HDMI_SLIPHDMIT_PARAM_SETTINGS_5);
+ hdmi_write(hdmi, 0x1e, HDMI_SLIPHDMIT_PARAM_SETTINGS_6);
+ hdmi_write(hdmi, 0x48, HDMI_SLIPHDMIT_PARAM_SETTINGS_7);
+ hdmi_write(hdmi, 0x0e, HDMI_SLIPHDMIT_PARAM_SETTINGS_8);
+ hdmi_write(hdmi, 0x25, HDMI_SLIPHDMIT_PARAM_SETTINGS_9);
+ hdmi_write(hdmi, 0x04, HDMI_SLIPHDMIT_PARAM_SETTINGS_10);
+ } else if (hdmi->var.pixclock < 30000) {
/* 720p, 8bit, 74.25MHz. Might need to be adjusted for other formats */
/*
* [1:0] Speed_A
@@ -527,6 +538,7 @@ static void sh_hdmi_phy_config(struct sh_hdmi *hdmi)
*/
static void sh_hdmi_avi_infoframe_setup(struct sh_hdmi *hdmi)
{
+ struct fb_var_screeninfo *var = &hdmi->var;
u8 vic;
/* AVI InfoFrame */
@@ -568,17 +580,11 @@ static void sh_hdmi_avi_infoframe_setup(struct sh_hdmi *hdmi)
hdmi_write(hdmi, 0x00, HDMI_CTRL_PKT_BUF_ACCESS_PB3);
/*
- * VIC = 1280 x 720p: ignored if external config is used
- * Send 2 for 720 x 480p, 16 for 1080p, ignored in external mode
+ * VIC should be ignored if external config is used, so, we could just use 0,
+ * but play safe and use a valid value in any case just in case
*/
- if (hdmi->var.yres = 1080 && hdmi->var.xres = 1920)
- vic = 16;
- else if (hdmi->var.yres = 576 && hdmi->var.xres = 720)
- vic = 17;
- else if (hdmi->var.yres = 480 && hdmi->var.xres = 720)
- vic = 2;
- else if (hdmi->var.yres = 480 && hdmi->var.xres = 640)
- vic = 1;
+ if (hdmi->preprogrammed_vic)
+ vic = hdmi->preprogrammed_vic;
else
vic = 4;
hdmi_write(hdmi, vic, HDMI_CTRL_PKT_BUF_ACCESS_PB4);
@@ -862,17 +868,25 @@ static int sh_hdmi_read_edid(struct sh_hdmi *hdmi, unsigned long *hdmi_rate,
if (!found)
return -ENXIO;
- if ((found->xres = 640 && found->yres = 480 && found->refresh = 60) ||
- (found->xres = 720 && found->yres = 480 && found->refresh = 60) ||
- (found->xres = 720 && found->yres = 576 && found->refresh = 50) ||
- (found->xres = 1280 && found->yres = 720 && found->refresh = 60) ||
- (found->xres = 1920 && found->yres = 1080 && found->refresh = 60))
- hdmi->preprogrammed_mode = true;
+ if (found->xres = 640 && found->yres = 480 && found->refresh = 60)
+ hdmi->preprogrammed_vic = 1;
+ else if (found->xres = 720 && found->yres = 480 && found->refresh = 60)
+ hdmi->preprogrammed_vic = 2;
+ else if (found->xres = 720 && found->yres = 576 && found->refresh = 50)
+ hdmi->preprogrammed_vic = 17;
+ else if (found->xres = 1280 && found->yres = 720 && found->refresh = 60)
+ hdmi->preprogrammed_vic = 4;
+ else if (found->xres = 1920 && found->yres = 1080 && found->refresh = 24)
+ hdmi->preprogrammed_vic = 32;
+ else if (found->xres = 1920 && found->yres = 1080 && found->refresh = 50)
+ hdmi->preprogrammed_vic = 31;
+ else if (found->xres = 1920 && found->yres = 1080 && found->refresh = 60)
+ hdmi->preprogrammed_vic = 16;
else
- hdmi->preprogrammed_mode = false;
+ hdmi->preprogrammed_vic = 0;
dev_dbg(hdmi->dev, "Using %s %s mode %ux%u@%uHz (%luHz), clock error %luHz\n",
- modelist ? "default" : "EDID", hdmi->preprogrammed_mode ? "VIC" : "external",
+ modelist ? "default" : "EDID", hdmi->preprogrammed_vic ? "VIC" : "external",
found->xres, found->yres, found->refresh,
PICOS2KHZ(found->pixclock) * 1000, found_rate_error);
--
1.7.2.3
^ permalink raw reply related [flat|nested] only message in thread
only message in thread, other threads:[~2010-11-04 11:06 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2010-11-04 11:06 [PATCH 5/5] fbdev: sh_mobile_hdmi: add support for 1080p modes Guennadi Liakhovetski
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).