[RFC 03/11] pmem: enable REQ_FLUSH handling

[Ross Zwisler <ross.zwisler@linux.intel.com>]

Currently the PMEM driver doesn't accept REQ_FLUSH bios.  These are sent
down via blkdev_issue_flush() in response to a fsync() or msync().

When we get an msync() or fsync() it is the responsibility of the DAX code
to flush all dirty pages to media.  The PMEM driver then just has issue a
wmb_pmem() in response to the REQ_FLUSH to ensure that before we return all
the flushed data has been durably stored on the media.

Signed-off-by: Ross Zwisler <ross.zwisler@linux.intel.com>
---
 drivers/nvdimm/pmem.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/nvdimm/pmem.c b/drivers/nvdimm/pmem.c
index 0ba6a97..e1e222e 100644
--- a/drivers/nvdimm/pmem.c
+++ b/drivers/nvdimm/pmem.c
@@ -80,7 +80,7 @@ static void pmem_make_request(struct request_queue *q, struct bio *bio)
 	if (do_acct)
 		nd_iostat_end(bio, start);
 
-	if (bio_data_dir(bio))
+	if (bio_data_dir(bio) || (bio->bi_rw & REQ_FLUSH))
 		wmb_pmem();
 
 	bio_endio(bio);
@@ -189,6 +189,7 @@ static int pmem_attach_disk(struct device *dev,
 	blk_queue_physical_block_size(pmem->pmem_queue, PAGE_SIZE);
 	blk_queue_max_hw_sectors(pmem->pmem_queue, UINT_MAX);
 	blk_queue_bounce_limit(pmem->pmem_queue, BLK_BOUNCE_ANY);
+	blk_queue_flush(pmem->pmem_queue, REQ_FLUSH);
 	queue_flag_set_unlocked(QUEUE_FLAG_NONROT, pmem->pmem_queue);
 
 	disk = alloc_disk(0);
-- 
2.1.0

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@kvack.org.  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>