From: Jamie Lokier <jamie@shareable.org>
To: Ric Wheeler <ricwheeler@gmail.com>
Cc: Theodore Tso <tytso@mit.edu>,
Chris Mason <chris.mason@oracle.com>,
Andrew Morton <akpm@linux-foundation.org>,
Eric Sandeen <sandeen@redhat.com>,
linux-ext4@vger.kernel.org, linux-kernel@vger.kernel.org,
linux-fsdevel@vger.kernel.org
Subject: Re: [PATCH 0/4] (RESEND) ext3[34] barrier changes
Date: Wed, 21 May 2008 00:48:20 +0100 [thread overview]
Message-ID: <20080520234820.GM27853@shareable.org> (raw)
In-Reply-To: <4830420D.4080608@gmail.com>
Ric Wheeler wrote:
> The hard thing is to figure out how to test this kind of scenario
> without dropping power.
Apart from using virtual machines, you mean?
> To expose the failure mode, it might be
> sufficient to drop power to a drive with smartctl (or, if you have hot
> swap bays, just pull them).
I wonder, does sending any kind of reset commands to drives cause them
to discard their write cache?
If the hot swap power switch is accessible from software, that would
be a nice trick :-)
-- Jamie
next prev parent reply other threads:[~2008-05-20 23:48 UTC|newest]
Thread overview: 78+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-05-16 19:02 [PATCH 0/4] (RESEND) ext3[34] barrier changes Eric Sandeen
2008-05-16 19:05 ` [PATCH 1/4] ext3: enable barriers by default Eric Sandeen
2008-05-19 8:58 ` Pavel Machek
2008-05-16 19:07 ` [PATCH 2/4] ext3: call blkdev_issue_flush on fsync Eric Sandeen
2008-05-16 22:15 ` Jamie Lokier
2008-05-16 19:08 ` [PATCH 3/4] ext4: enable barriers by default Eric Sandeen
2008-05-16 19:09 ` [PATCH 4/4] ext4: call blkdev_issue_flush on fsync Eric Sandeen
2008-05-20 2:34 ` Theodore Tso
2008-05-20 15:43 ` Jamie Lokier
2008-05-20 15:52 ` Eric Sandeen
2008-05-20 19:54 ` Jens Axboe
2008-05-20 22:02 ` Jamie Lokier
2008-05-21 7:30 ` Jens Axboe
[not found] ` <4832F3C6.1050601@redhat.com>
2008-05-20 20:14 ` Jens Axboe
2008-05-16 20:05 ` [PATCH 0/4] (RESEND) ext3[34] barrier changes Andrew Morton
2008-05-16 20:53 ` Eric Sandeen
2008-05-16 20:58 ` Andrew Morton
2008-05-16 21:45 ` Jamie Lokier
2008-05-16 22:03 ` Eric Sandeen
2008-05-16 22:09 ` Jamie Lokier
2008-05-16 22:03 ` Jamie Lokier
2008-05-16 22:21 ` Eric Sandeen
2008-05-16 22:53 ` Jamie Lokier
2008-05-17 0:20 ` Theodore Tso
2008-05-17 0:35 ` Andrew Morton
2008-05-17 13:43 ` Theodore Tso
2008-05-17 17:59 ` Andreas Dilger
2008-05-17 20:44 ` Theodore Tso
2008-05-20 14:45 ` Jamie Lokier
2008-05-18 0:48 ` Chris Mason
2008-05-18 1:36 ` Theodore Tso
2008-05-18 14:49 ` Ric Wheeler
[not found] ` <4830420D.4080608@gmail.com>
2008-05-20 14:42 ` Jamie Lokier
2008-05-20 23:48 ` Jamie Lokier [this message]
2008-05-20 23:44 ` Jamie Lokier
2008-05-18 20:03 ` Andi Kleen
2008-05-19 0:43 ` Theodore Tso
2008-05-19 2:29 ` Eric Sandeen
[not found] ` <4830E60A.2010809@redhat.com>
2008-05-19 4:11 ` Andrew Morton
2008-05-19 17:16 ` Chris Mason
2008-05-19 18:39 ` Chris Mason
2008-05-19 22:39 ` Jan Kara
2008-05-20 0:29 ` Chris Mason
2008-05-20 3:29 ` Timothy Shimmin
2008-05-20 12:04 ` Chris Mason
2008-05-20 8:25 ` Jens Axboe
2008-05-20 12:17 ` Chris Mason
2008-05-21 11:22 ` Pavel Machek
2008-05-21 12:32 ` Theodore Tso
2008-05-21 18:03 ` Andrew Morton
2008-05-21 18:15 ` Eric Sandeen
2008-05-21 19:43 ` Jamie Lokier
2008-05-21 18:29 ` Theodore Tso
2008-05-21 18:49 ` Andrew Morton
2008-05-21 19:42 ` Jamie Lokier
2008-05-21 19:36 ` Jamie Lokier
[not found] ` <20080521193633.GA26780@shareable.org>
2008-05-21 19:40 ` Chris Mason
2008-05-21 19:54 ` Jamie Lokier
2008-05-20 14:58 ` Jamie Lokier
2008-05-21 22:30 ` Daniel Phillips
2008-05-20 23:35 ` Jamie Lokier
2008-05-19 0:28 ` Theodore Tso
2008-05-20 15:13 ` Jamie Lokier
[not found] ` <20080520151306.GF16676@shareable.org>
2008-05-21 20:25 ` Greg Smith
2008-05-16 22:30 ` Jamie Lokier
2008-05-18 19:54 ` Andi Kleen
2008-05-19 13:26 ` Chris Mason
2008-05-19 14:46 ` Theodore Tso
2008-05-20 2:51 ` [PATCH, RFC] ext4: Fix use of write barrier in commit logic Theodore Tso
[not found] ` <20080520025112.GN15035@mit.edu>
2008-05-20 15:23 ` Jamie Lokier
2008-05-23 18:33 ` [PATCH 0/4] (RESEND) ext3[34] barrier changes Ric Wheeler
2008-05-20 15:36 ` Jamie Lokier
2008-05-20 16:02 ` Chris Mason
2008-05-20 16:27 ` Jamie Lokier
2008-05-20 17:08 ` Chris Mason
2008-05-20 22:26 ` Jamie Lokier
2008-05-19 9:04 ` Pavel Machek
2008-05-29 13:36 ` Eric Sandeen
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20080520234820.GM27853@shareable.org \
--to=jamie@shareable.org \
--cc=akpm@linux-foundation.org \
--cc=chris.mason@oracle.com \
--cc=linux-ext4@vger.kernel.org \
--cc=linux-fsdevel@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=ricwheeler@gmail.com \
--cc=sandeen@redhat.com \
--cc=tytso@mit.edu \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).