From: Matthew Wilcox <willy@infradead.org>
To: Ritesh Harjani <ritesh.list@gmail.com>
Cc: Jan Kara <jack@suse.cz>, Theodore Ts'o <tytso@mit.edu>,
linux-ext4@vger.kernel.org, linux-fsdevel@vger.kernel.org,
Ojaswin Mujoo <ojaswin@linux.ibm.com>,
Disha Goel <disgoel@linux.ibm.com>
Subject: Re: [RFCv2 2/5] ext4: Remove PAGE_SIZE assumption of folio from mpage_submit_folio
Date: Tue, 13 Jun 2023 20:45:07 +0100 [thread overview]
Message-ID: <ZIjHQ5Nea7eRLjzF@casper.infradead.org> (raw)
In-Reply-To: <87o7ljw3qo.fsf@doe.com>
On Wed, Jun 14, 2023 at 01:09:59AM +0530, Ritesh Harjani wrote:
> Jan Kara <jack@suse.cz> writes:
>
> > On Tue 13-06-23 09:27:38, Ritesh Harjani wrote:
> >> Matthew Wilcox <willy@infradead.org> writes:
> >> > On Mon, Jun 12, 2023 at 11:55:55PM +0530, Ritesh Harjani wrote:
> >> >> Matthew Wilcox <willy@infradead.org> writes:
> >> >> I couldn't respond to your change because I still had some confusion
> >> >> around this suggestion -
> >> >>
> >> >> > So do we care if we write a random fragment of a page after a truncate?
> >> >> > If so, we should add:
> >> >> >
> >> >> > if (folio_pos(folio) >= size)
> >> >> > return 0; /* Do we need to account nr_to_write? */
> >> >>
> >> >> I was not sure whether if go with above case then whether it will
> >> >> work with collapse_range. I initially thought that collapse_range will
> >> >> truncate the pages between start and end of the file and then
> >> >> it can also reduce the inode->i_size. That means writeback can find an
> >> >> inode->i_size smaller than folio_pos(folio) which it is writing to.
> >> >> But in this case we can't skip the write in writeback case like above
> >> >> because that write is still required (a spurious write) even though
> >> >> i_size is reduced as it's corresponding FS blocks are not truncated.
> >> >>
> >> >> But just now looking at ext4_collapse_range() code it doesn't look like
> >> >> it is the problem because it waits for any dirty data to be written
> >> >> before truncate. So no matter which folio_pos(folio) the writeback is
> >> >> writing, there should not be an issue if we simply return 0 like how
> >> >> you suggested above.
> >> >>
> >> >> static int ext4_collapse_range(struct file *file, loff_t offset, loff_t len)
> >> >>
> >> >> <...>
> >> >> ioffset = round_down(offset, PAGE_SIZE);
> >> >> /*
> >> >> * Write tail of the last page before removed range since it will get
> >> >> * removed from the page cache below.
> >> >> */
> >> >>
> >> >> ret = filemap_write_and_wait_range(mapping, ioffset, offset);
> >> >> if (ret)
> >> >> goto out_mmap;
> >> >> /*
> >> >> * Write data that will be shifted to preserve them when discarding
> >> >> * page cache below. We are also protected from pages becoming dirty
> >> >> * by i_rwsem and invalidate_lock.
> >> >> */
> >> >> ret = filemap_write_and_wait_range(mapping, offset + len,
> >> >> LLONG_MAX);
> >> >> truncate_pagecache(inode, ioffset);
> >> >>
> >> >> <... within i_data_sem>
> >> >> i_size_write(inode, new_size);
> >> >>
> >> >> <...>
> >> >>
> >> >>
> >> >> However to avoid problems like this I felt, I will do some more code
> >> >> reading. And then I was mostly considering your second suggestion which
> >> >> is this. This will ensure we keep the current behavior as is and not
> >> >> change that.
> >> >>
> >> >> > If we simply don't care that we're doing a spurious write, then we can
> >> >> > do something like:
> >> >> >
> >> >> > - len = size & ~PAGE_MASK;
> >> >> > + len = size & (len - 1);
> >> >
> >> > For all I know, I've found a bug here. I don't know enough about ext4; if
> >> > we have truncated a file, and then writeback a page that is past i_size,
> >> > will the block its writing to have been freed?
> >>
> >> I don't think so. If we look at truncate code, it first reduces i_size,
> >> then call truncate_pagecache(inode, newsize) and then we will call
> >> ext4_truncate() which will free the corresponding blocks.
> >> Since writeback happens with folio lock held until completion, hence I
> >> think truncate_pagecache() should block on that folio until it's lock
> >> has been released.
> >>
> >> - IIUC, if truncate would have completed then the folio won't be in the
> >> foliocache for writeback to happen. Foliocache is kept consistent
> >> via
> >> - first truncate the folio in the foliocache and then remove/free
> >> the blocks on device.
> >
> > Yes, correct.
> >
> >> - Also the reason we update i_size "before" calling truncate_pagecache()
> >> is to synchronize with mmap/pagefault.
> >
> > Yes, but these days mapping->invalidate_lock works for that instead for
> > ext4.
> >
> >> > Is this potentially a silent data corruptor?
> >>
> >> - Let's consider a case when folio_pos > i_size but both still belongs
> >> to the last block. i.e. it's a straddle write case.
> >> In such case we require writeback to write the data of this last folio
> >> straddling i_size. Because truncate will not remove/free this last folio
> >> straddling i_size & neither the last block will be freed. And I think
> >> writeback is supposed to write this last folio to the disk to keep the
> >> cache and disk data consistent. Because truncate will only zero out
> >> the rest of the folio in the foliocache. But I don't think it will go and
> >> write that folio out (It's not required because i_size means that the
> >> rest of the folio beyond i_size should remain zero).
> >>
> >> So, IMO writeback is supposed to write this last folio to the disk. And,
> >> if we skip this writeout, then I think it may cause silent data corruption.
> >>
> >> But I am not sure about the rest of the write beyond the last block of
> >> i_size. I think those could just be spurious writes which won't cause
> >> any harm because truncate will eventually first remove this folio from
> >> file mapping and then will release the corresponding disk blocks.
> >> So writing those out should does no harm
> >
> > Correct. The block straddling i_size must be written out, the blocks fully
> > beyond new i_size (but below old i_size) may or may not be written out. As
> > you say these extra racing writes to blocks that will get truncated cause
> > no harm.
> >
>
> Thanks Jan for confirming. So, I think we should make below change.
> (note the code which was doing "size - folio_pos(folio)" in
> mpage_submit_folio() is dropped by Ted in the latest tree).
>
> diff --git a/fs/ext4/inode.c b/fs/ext4/inode.c
> index 43be684dabcb..006eba9be5e6 100644
> --- a/fs/ext4/inode.c
> +++ b/fs/ext4/inode.c
> @@ -1859,9 +1859,9 @@ static int mpage_submit_folio(struct mpage_da_data *mpd, struct folio *folio)
> */
> size = i_size_read(mpd->inode);
> len = folio_size(folio);
> - if (folio_pos(folio) + len > size &&
> + if ((folio_pos(folio) >= size || (folio_pos(folio) + len > size)) &&
> !ext4_verity_in_progress(mpd->inode))
> - len = size & ~PAGE_MASK;
> + len = size & (len - 1);
> err = ext4_bio_write_folio(&mpd->io_submit, folio, len);
> if (!err)
> mpd->wbc->nr_to_write--;
> @@ -2329,9 +2329,9 @@ static int mpage_journal_page_buffers(handle_t *handle,
> folio_clear_checked(folio);
> mpd->wbc->nr_to_write--;
>
> - if (folio_pos(folio) + len > size &&
> + if ((folio_pos(folio) >= size || (folio_pos(folio) + len > size)) &&
> !ext4_verity_in_progress(inode))
> - len = size - folio_pos(folio);
> + len = size & (len - 1);
>
> return ext4_journal_folio_buffers(handle, folio, len);
> }
>
>
> I will give it some more thoughts and testing.
Why should ext4 be different from other filesystems which simply do:
if (folio_pos(folio) >= size)
return 0;
next prev parent reply other threads:[~2023-06-13 19:45 UTC|newest]
Thread overview: 24+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-05-15 10:40 [RFCv2 0/5] ext4: misc left over folio changes Ritesh Harjani (IBM)
2023-05-15 10:40 ` [RFCv2 1/5] ext4: kill unused function ext4_journalled_write_inline_data Ritesh Harjani (IBM)
2023-05-15 10:40 ` [RFCv2 2/5] ext4: Remove PAGE_SIZE assumption of folio from mpage_submit_folio Ritesh Harjani (IBM)
2023-05-16 19:14 ` Matthew Wilcox
2023-06-11 5:58 ` Theodore Ts'o
2023-06-11 14:15 ` Matthew Wilcox
2023-06-11 14:25 ` Ritesh Harjani
2023-06-12 17:25 ` Ritesh Harjani
2023-06-12 17:43 ` Matthew Wilcox
2023-06-12 18:25 ` Ritesh Harjani
2023-06-12 19:16 ` Matthew Wilcox
2023-06-13 3:57 ` Ritesh Harjani
2023-06-13 9:59 ` Jan Kara
2023-06-13 19:39 ` Ritesh Harjani
2023-06-13 19:45 ` Matthew Wilcox [this message]
2023-06-13 20:43 ` Ritesh Harjani
2023-05-15 10:40 ` [RFCv2 3/5] ext4: Change remaining tracepoints to use folio Ritesh Harjani (IBM)
2023-05-15 10:40 ` [RFCv2 4/5] ext4: Make mpage_journal_page_buffers " Ritesh Harjani (IBM)
2023-05-16 19:16 ` Matthew Wilcox
2023-05-15 10:40 ` [RFCv2 5/5] ext4: Make ext4_write_inline_data_end() " Ritesh Harjani (IBM)
2023-05-16 19:27 ` [PATCH 6/5] ext4: Call fsverity_verify_folio() Matthew Wilcox (Oracle)
2023-05-17 6:45 ` Ritesh Harjani
2023-05-20 1:06 ` Eric Biggers
2023-06-09 3:14 ` [RFCv2 0/5] ext4: misc left over folio changes Theodore Ts'o
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=ZIjHQ5Nea7eRLjzF@casper.infradead.org \
--to=willy@infradead.org \
--cc=disgoel@linux.ibm.com \
--cc=jack@suse.cz \
--cc=linux-ext4@vger.kernel.org \
--cc=linux-fsdevel@vger.kernel.org \
--cc=ojaswin@linux.ibm.com \
--cc=ritesh.list@gmail.com \
--cc=tytso@mit.edu \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).