RE: [PATCH net-next v3 6/8] net: pcs: Add 10GBASE-R mode for Synopsys Designware XPCS

["Jiawen Wu" <jiawenwu@trustnetic.com>]

On Wednesday, April 19, 2023 9:20 PM, Vladimir Oltean wrote:
> On Wed, Apr 19, 2023 at 04:27:37PM +0800, Jiawen Wu wrote:
> > Add basic support for XPCS using 10GBASE-R interface. This mode will
> > be extended to use interrupt, so set pcs.poll false. And avoid soft
> > reset so that the device using this mode is in the default configuration.
> 
> I'm not clear why the xpcs_soft_reset() call is avoided. Isn't the
> out-of-reset configuration the "default" one?
> 

Theoretically so, I need to configure 10GBASE-R mode after reset. But this
configuration involves board info to configure PMA, etc., I'd like to implement
it in the next patch. Now the "default" configuration refers to the mode in
which the firmware is configured.

> > +static int xpcs_get_state_10gbaser(struct dw_xpcs *xpcs,
> > +				   struct phylink_link_state *state)
> > +{
> > +	int ret;
> > +
> > +	state->link = false;
> > +
> > +	ret = xpcs_read(xpcs, MDIO_MMD_PCS, MDIO_STAT1);
> > +	if (ret < 0)
> > +		return ret;
> > +
> > +	if (ret & MDIO_STAT1_LSTATUS)
> > +		state->link = true;
> > +
> > +	if (state->link) {
> 
> It seems pointless to open a new "if" statement when this would have
> sufficed:
> 
> 	if (ret & MDIO_STAT1_LSTATUS) {
> 		state->link = true;
> 		state->pause = MLO_PAUSE_TX | MLO_PAUSE_RX;
> 		...
> 	}
> 
> > +		state->pause = MLO_PAUSE_TX | MLO_PAUSE_RX;
> > +		state->duplex = DUPLEX_FULL;
> > +		state->speed = SPEED_10000;
> > +	}
> > +
> > +	return 0;
> > +}
>