From: "Shevchenko, Andriy" <andriy.shevchenko@intel.com>
To: "Chen, Alvin" <alvin.chen@intel.com>
Cc: "linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
"robh+dt@kernel.org" <robh+dt@kernel.org>,
"Kweh, Hock Leong" <hock.leong.kweh@intel.com>,
"sebastian@breakpoint.cc" <sebastian@breakpoint.cc>,
"devicetree@vger.kernel.org" <devicetree@vger.kernel.org>,
"Ong, Boon Leong" <boon.leong.ong@intel.com>,
"gnurou@gmail.com" <gnurou@gmail.com>,
"linus.walleij@linaro.org" <linus.walleij@linaro.org>,
"linux-gpio@vger.kernel.org" <linux-gpio@vger.kernel.org>,
"grant.likely@linaro.org" <grant.likely@linaro.org>,
"Westerberg, Mika" <mika.westerberg@intel.com>,
"dvhart@linux.intel.com" <dvhart@linux.intel.com>,
"arnd@arndb.de" <arnd@arndb.de>,
"atull@opensource.altera.com" <atull@opensource.altera.com>
Subject: Re: [PATCH 4/4 v4] GPIO: gpio-dwapb: Suspend & Resume PM enabling
Date: Tue, 16 Sep 2014 07:24:57 +0000 [thread overview]
Message-ID: <1410852297.7023.46.camel@intel.com> (raw)
In-Reply-To: <1410859335-11080-5-git-send-email-alvin.chen@intel.com>
On Tue, 2014-09-16 at 02:22 -0700, Weike Chen wrote:
> This patch enables suspend and resume mode for the power management, and
> it is based on Josef Ahmad's previous work.
>
Few comments below.
> Reviewed-by: Hock Leong Kweh <hock.leong.kweh@intel.com>
You still keep that guy as reviewer in a whole series, however I didn't
see a word from him here. How is it possible?
> Signed-off-by: Weike Chen <alvin.chen@intel.com>
> ---
> drivers/gpio/gpio-dwapb.c | 109 +++++++++++++++++++++++++++++++++++++++++++++
> 1 file changed, 109 insertions(+)
>
> diff --git a/drivers/gpio/gpio-dwapb.c b/drivers/gpio/gpio-dwapb.c
> index 9a76e3c..14d83af 100644
> --- a/drivers/gpio/gpio-dwapb.c
> +++ b/drivers/gpio/gpio-dwapb.c
> @@ -50,11 +50,14 @@
> #define GPIO_SWPORT_DDR_SIZE (GPIO_SWPORTB_DDR - GPIO_SWPORTA_DDR)
>
> struct dwapb_gpio;
> +struct dwapb_context;
>
> struct dwapb_gpio_port {
> struct bgpio_chip bgc;
> bool is_registered;
> struct dwapb_gpio *gpio;
> + struct dwapb_context *ctx;
> + unsigned int idx;
> };
>
> struct dwapb_gpio {
> @@ -377,6 +380,7 @@ static int dwapb_gpio_add_port(struct dwapb_gpio *gpio,
>
> port = &gpio->ports[offs];
> port->gpio = gpio;
> + port->idx = pp->idx;
>
> dat = gpio->regs + GPIO_EXT_PORTA + (pp->idx * GPIO_EXT_PORT_SIZE);
> set = gpio->regs + GPIO_SWPORTA_DR + (pp->idx * GPIO_SWPORT_DR_SIZE);
> @@ -584,10 +588,115 @@ static const struct of_device_id dwapb_of_match[] = {
> };
> MODULE_DEVICE_TABLE(of, dwapb_of_match);
>
> +#ifdef CONFIG_PM_SLEEP
> +/* Store GPIO context across system-wide suspend/resume transitions */
> +struct dwapb_context {
> + u32 data;
> + u32 dir;
> + u32 ext;
> + u32 int_en;
> + u32 int_mask;
> + u32 int_type;
> + u32 int_pol;
> + u32 int_deb;
> +};
> +
> +static int dwapb_gpio_suspend(struct device *dev)
> +{
> + struct platform_device *pdev = to_platform_device(dev);
> + struct dwapb_gpio *gpio = platform_get_drvdata(pdev);
> + struct bgpio_chip *bgc = &gpio->ports[0].bgc;
> + unsigned long flags;
> + int i;
> +
> + spin_lock_irqsave(&bgc->lock, flags);
> + for (i = 0; i < gpio->nr_ports; i++) {
> + unsigned int offset;
> + unsigned int idx = gpio->ports[i].idx;
> + struct dwapb_context *ctx = gpio->ports[i].ctx;
> +
> + if (!ctx) {
> + ctx = devm_kzalloc(dev, sizeof(*ctx), GFP_KERNEL);
> + gpio->ports[i].ctx = ctx;
> + }
I don't think it's a right place to allocate this resource, especially
with devm_ helper. Can you move this to probe() stage?
Or you even can embed contex structure inside chip one with #ifdef
CONFIG_PM_SLEEP.
Maybe others could comment on this.
> +
> + offset = GPIO_SWPORTA_DDR + (idx * GPIO_SWPORT_DDR_SIZE);
No need to have parentheses here. Check the code below as well.
> + ctx->dir = dwapb_read(gpio, offset);
> +
> + offset = GPIO_SWPORTA_DR + (idx * GPIO_SWPORT_DR_SIZE);
> + ctx->data = dwapb_read(gpio, offset);
> +
> + offset = GPIO_EXT_PORTA + (idx * GPIO_EXT_PORT_SIZE);
> + ctx->ext = dwapb_read(gpio, offset);
> +
> + /* Only port A can provide interrupts */
> + if (idx == 0) {
> + ctx->int_mask = dwapb_read(gpio, GPIO_INTMASK);
> + ctx->int_en = dwapb_read(gpio, GPIO_INTEN);
> + ctx->int_pol = dwapb_read(gpio, GPIO_INT_POLARITY);
> + ctx->int_type = dwapb_read(gpio, GPIO_INTTYPE_LEVEL);
> + ctx->int_deb = dwapb_read(gpio, GPIO_PORTA_DEBOUNCE);
> +
> + /* Mask out interrupts */
> + dwapb_write(gpio, GPIO_INTMASK, 0xffffffff);
> + }
> + }
> + spin_unlock_irqrestore(&bgc->lock, flags);
> +
> + return 0;
> +}
> +
> +static int dwapb_gpio_resume(struct device *dev)
> +{
> + struct platform_device *pdev = to_platform_device(dev);
> + struct dwapb_gpio *gpio = platform_get_drvdata(pdev);
> + struct bgpio_chip *bgc = &gpio->ports[0].bgc;
> + unsigned long flags;
> + int i;
> +
> + spin_lock_irqsave(&bgc->lock, flags);
> + for (i = 0; i < gpio->nr_ports; i++) {
> + unsigned int offset;
> + unsigned int idx = gpio->ports[i].idx;
> + struct dwapb_context *ctx = gpio->ports[i].ctx;
> +
> + BUG_ON(ctx == 0);
> +
> + offset = GPIO_SWPORTA_DR + (idx * GPIO_SWPORT_DR_SIZE);
> + dwapb_write(gpio, offset, ctx->data);
> +
> + offset = GPIO_SWPORTA_DDR + (idx * GPIO_SWPORT_DDR_SIZE);
> + dwapb_write(gpio, offset, ctx->dir);
> +
> + offset = GPIO_EXT_PORTA + (idx * GPIO_EXT_PORT_SIZE);
> + dwapb_write(gpio, offset, ctx->ext);
> +
> + /* Only port A can provide interrupts */
> + if (idx == 0) {
> + dwapb_write(gpio, GPIO_INTTYPE_LEVEL, ctx->int_type);
> + dwapb_write(gpio, GPIO_INT_POLARITY, ctx->int_pol);
> + dwapb_write(gpio, GPIO_PORTA_DEBOUNCE, ctx->int_deb);
> + dwapb_write(gpio, GPIO_INTEN, ctx->int_en);
> + dwapb_write(gpio, GPIO_INTMASK, ctx->int_mask);
> +
> + /* Clear out spurious interrupts */
> + dwapb_write(gpio, GPIO_PORTA_EOI, 0xffffffff);
> + }
> + }
> + spin_unlock_irqrestore(&bgc->lock, flags);
> +
> + return 0;
> +}
> +#endif
> +
> +static SIMPLE_DEV_PM_OPS(dwapb_gpio_pm_ops, dwapb_gpio_suspend,
> + dwapb_gpio_resume);
> +
> static struct platform_driver dwapb_gpio_driver = {
> .driver = {
> .name = "gpio-dwapb",
> .owner = THIS_MODULE,
> + .pm = &dwapb_gpio_pm_ops,
> .of_match_table = of_match_ptr(dwapb_of_match),
> },
> .probe = dwapb_gpio_probe,
--
Andy Shevchenko <andriy.shevchenko@intel.com>
Intel Finland Oy
---------------------------------------------------------------------
Intel Finland Oy
Registered Address: PL 281, 00181 Helsinki
Business Identity Code: 0357606 - 4
Domiciled in Helsinki
This e-mail and any attachments may contain confidential material for
the sole use of the intended recipient(s). Any review or distribution
by others is strictly prohibited. If you are not the intended
recipient, please contact the sender and delete all copies.
next prev parent reply other threads:[~2014-09-16 7:29 UTC|newest]
Thread overview: 12+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-09-16 9:22 [PATCH 0/4 v4] The Designware GPIO Supporting Weike Chen
2014-09-16 9:22 ` [PATCH 1/4 v4] GPIO: gpio-dwapb: Enable platform driver binding to MFD driver Weike Chen
2014-09-16 14:22 ` atull
2014-09-17 7:09 ` Chen, Alvin
2014-09-16 9:22 ` [PATCH 2/4 v4] GPIO: gpio-dwapb: Change readl&writel to dwapb_read&dwapb_write Weike Chen
2014-09-16 9:22 ` [PATCH 3/4 v4] GPIO: gpio-dwapb: Support Debounce Weike Chen
2014-09-16 8:37 ` Andy Shevchenko
2014-09-17 6:47 ` Chen, Alvin
2014-09-16 9:22 ` [PATCH 4/4 v4] GPIO: gpio-dwapb: Suspend & Resume PM enabling Weike Chen
2014-09-16 7:24 ` Shevchenko, Andriy [this message]
[not found] ` <1410859335-11080-5-git-send-email-alvin.chen-ral2JQCrhuEAvxtiuMwx3w@public.gmane.org>
2014-09-16 7:26 ` Andy Shevchenko
2014-09-17 6:46 ` Chen, Alvin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1410852297.7023.46.camel@intel.com \
--to=andriy.shevchenko@intel.com \
--cc=alvin.chen@intel.com \
--cc=arnd@arndb.de \
--cc=atull@opensource.altera.com \
--cc=boon.leong.ong@intel.com \
--cc=devicetree@vger.kernel.org \
--cc=dvhart@linux.intel.com \
--cc=gnurou@gmail.com \
--cc=grant.likely@linaro.org \
--cc=hock.leong.kweh@intel.com \
--cc=linus.walleij@linaro.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=mika.westerberg@intel.com \
--cc=robh+dt@kernel.org \
--cc=sebastian@breakpoint.cc \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).