From: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
To: Weike Chen <alvin.chen@intel.com>
Cc: Linus Walleij <linus.walleij@linaro.org>,
Alexandre Courbot <gnurou@gmail.com>,
Grant Likely <grant.likely@linaro.org>,
Rob Herring <robh+dt@kernel.org>,
atull <atull@opensource.altera.com>,
linux-gpio@vger.kernel.org, linux-kernel@vger.kernel.org,
devicetree@vger.kernel.org,
Boon Leong Ong <boon.leong.ong@intel.com>,
Hock Leong Kweh <hock.leong.kweh@intel.com>,
Darren Hart <dvhart@linux.intel.com>,
Sebastian Andrzej Siewior <sebastian@breakpoint.cc>,
Mika Westerberg <mika.westerberg@intel.com>,
Arnd Bergmann <arnd@arndb.de>
Subject: Re: [PATCH 3/4 v4] GPIO: gpio-dwapb: Support Debounce
Date: Tue, 16 Sep 2014 11:37:49 +0300 [thread overview]
Message-ID: <1410856669.7023.54.camel@linux.intel.com> (raw)
In-Reply-To: <1410859335-11080-4-git-send-email-alvin.chen@intel.com>
On Tue, 2014-09-16 at 02:22 -0700, Weike Chen wrote:
> This patch enables 'debounce' for the designware GPIO, and
> it is based on Josef Ahmad's previous work.
>
> Reviewed-by: Hock Leong Kweh <hock.leong.kweh@intel.com>
> Reviewed-by: Shevchenko, Andriy <andriy.shevchenko@intel.com>
This line is wrong. How come?
Couple of minor comments below, and after addressing them, please, use
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
> Signed-off-by: Weike Chen <alvin.chen@intel.com>
> ---
> drivers/gpio/gpio-dwapb.c | 28 ++++++++++++++++++++++++++++
> 1 file changed, 28 insertions(+)
>
> diff --git a/drivers/gpio/gpio-dwapb.c b/drivers/gpio/gpio-dwapb.c
> index 534945c..9a76e3c 100644
> --- a/drivers/gpio/gpio-dwapb.c
> +++ b/drivers/gpio/gpio-dwapb.c
> @@ -37,6 +37,7 @@
> #define GPIO_INTTYPE_LEVEL 0x38
> #define GPIO_INT_POLARITY 0x3c
> #define GPIO_INTSTATUS 0x40
> +#define GPIO_PORTA_DEBOUNCE 0x48
> #define GPIO_PORTA_EOI 0x4c
> #define GPIO_EXT_PORTA 0x50
> #define GPIO_EXT_PORTB 0x54
> @@ -235,6 +236,29 @@ static int dwapb_irq_set_type(struct irq_data *d, u32 type)
> return 0;
> }
>
> +static int dwapb_gpio_set_debounce(struct gpio_chip *gc,
> + unsigned offset, unsigned debounce)
> +{
> + struct bgpio_chip *bgc = to_bgpio_chip(gc);
> + struct dwapb_gpio_port *port =
> + container_of(bgc, struct dwapb_gpio_port, bgc);
Does it make sense to introduce an inline helper like
static inline struct dwapb_gpio_port *to_dwapb_gpio_port(struct
bgpio_chip *gc)
{...}
?
There is also another place where it could be used.
> + struct dwapb_gpio *gpio = port->gpio;
> + unsigned long flags, val_deb;
> + unsigned long mask = bgc->pin2mask(bgc, offset);
> +
> + spin_lock_irqsave(&bgc->lock, flags);
> +
> + val_deb = dwapb_read(gpio, GPIO_PORTA_DEBOUNCE);
> + if (debounce)
> + dwapb_write(gpio, GPIO_PORTA_DEBOUNCE, mask | val_deb);
May you put value on the first place? Like 'val_deb | mask'.
> + else
> + dwapb_write(gpio, GPIO_PORTA_DEBOUNCE, ~mask & val_deb);
Ditto.
> +
> + spin_unlock_irqrestore(&bgc->lock, flags);
> +
> + return 0;
> +}
> +
> static irqreturn_t dwapb_irq_handler_mfd(int irq, void *dev_id)
> {
> u32 worked;
> @@ -373,6 +397,10 @@ static int dwapb_gpio_add_port(struct dwapb_gpio *gpio,
> port->bgc.gc.ngpio = pp->ngpio;
> port->bgc.gc.base = pp->gpio_base;
>
> + /* Only port A support debounce */
> + if (pp->idx == 0)
> + port->bgc.gc.set_debounce = dwapb_gpio_set_debounce;
> +
> if (pp->irq)
> dwapb_configure_irqs(gpio, port, pp);
>
--
Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Intel Finland Oy
next prev parent reply other threads:[~2014-09-16 8:37 UTC|newest]
Thread overview: 12+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-09-16 9:22 [PATCH 0/4 v4] The Designware GPIO Supporting Weike Chen
2014-09-16 9:22 ` [PATCH 1/4 v4] GPIO: gpio-dwapb: Enable platform driver binding to MFD driver Weike Chen
2014-09-16 14:22 ` atull
2014-09-17 7:09 ` Chen, Alvin
2014-09-16 9:22 ` [PATCH 2/4 v4] GPIO: gpio-dwapb: Change readl&writel to dwapb_read&dwapb_write Weike Chen
2014-09-16 9:22 ` [PATCH 3/4 v4] GPIO: gpio-dwapb: Support Debounce Weike Chen
2014-09-16 8:37 ` Andy Shevchenko [this message]
2014-09-17 6:47 ` Chen, Alvin
2014-09-16 9:22 ` [PATCH 4/4 v4] GPIO: gpio-dwapb: Suspend & Resume PM enabling Weike Chen
2014-09-16 7:24 ` Shevchenko, Andriy
[not found] ` <1410859335-11080-5-git-send-email-alvin.chen-ral2JQCrhuEAvxtiuMwx3w@public.gmane.org>
2014-09-16 7:26 ` Andy Shevchenko
2014-09-17 6:46 ` Chen, Alvin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1410856669.7023.54.camel@linux.intel.com \
--to=andriy.shevchenko@linux.intel.com \
--cc=alvin.chen@intel.com \
--cc=arnd@arndb.de \
--cc=atull@opensource.altera.com \
--cc=boon.leong.ong@intel.com \
--cc=devicetree@vger.kernel.org \
--cc=dvhart@linux.intel.com \
--cc=gnurou@gmail.com \
--cc=grant.likely@linaro.org \
--cc=hock.leong.kweh@intel.com \
--cc=linus.walleij@linaro.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=mika.westerberg@intel.com \
--cc=robh+dt@kernel.org \
--cc=sebastian@breakpoint.cc \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).