From mboxrd@z Thu Jan 1 00:00:00 1970 From: Alexander Shiyan Subject: [PATCH v2 2/2] GPIO: 74xx-mmio: Add DT bindings documentation Date: Fri, 3 Oct 2014 11:32:15 +0400 Message-ID: <1412321535-28441-1-git-send-email-shc_work@mail.ru> Return-path: Received: from fallback6.mail.ru ([94.100.181.147]:50345 "EHLO fallback6.mail.ru" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1750754AbaJCHdL (ORCPT ); Fri, 3 Oct 2014 03:33:11 -0400 Sender: linux-gpio-owner@vger.kernel.org List-Id: linux-gpio@vger.kernel.org To: Linus Walleij Cc: Alexandre Courbot , linux-gpio@vger.kernel.org, devicetree@vger.kernel.org, Alexander Shiyan This patch adds DT binding documentation for the 74xx-mmio GPIO driver. Signed-off-by: Alexander Shiyan --- .../devicetree/bindings/gpio/gpio-74xx-mmio.txt | 30 ++++++++++++++++++++++ 1 file changed, 30 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/gpio-74xx-mmio.txt diff --git a/Documentation/devicetree/bindings/gpio/gpio-74xx-mmio.txt b/Documentation/devicetree/bindings/gpio/gpio-74xx-mmio.txt new file mode 100644 index 0000000..7bb1a9d --- /dev/null +++ b/Documentation/devicetree/bindings/gpio/gpio-74xx-mmio.txt @@ -0,0 +1,30 @@ +* 74XX MMIO GPIO driver + +Required properties: +- compatible: Should contain one of the following: + "ti,741g125": for 741G125 (1-bit Input), + "ti,741g174": for 741G74 (1-bit Output), + "ti,742g125": for 742G125 (2-bit Input), + "ti,7474" : for 7474 (2-bit Output), + "ti,74125" : for 74125 (4-bit Input), + "ti,74175" : for 74175 (4-bit Output), + "ti,74365" : for 74365 (6-bit Input), + "ti,74174" : for 74174 (6-bit Output), + "ti,74244" : for 74244 (8-bit Input), + "ti,74273" : for 74273 (8-bit Output), + "ti,741624" : for 741624 (16-bit Input), + "ti,7416374": for 7416374 (16-bit Output). +- reg: Physical base address and length where IC resides. +- gpio-controller: Marks the device node as a gpio controller. +- #gpio-cells: Should be two. The first cell is the pin number and + the second cell is used to specify the GPIO polarity: + 0 = Active High, + 1 = Active Low. + +Example: + ctrl: gpio@30008004 { + compatible = "ti,74174"; + reg = <0x30008004 0x1>; + gpio-controller; + #gpio-cells = <2>; + }; -- 2.0.4