[PATCH 6/8] gpio: omap: get rid of GPIO_BIT() macro

[<grygorii.strashko@linaro.org>]

From: Grygorii Strashko <grygorii.strashko@linaro.org>

Now OMAP GPIO driver prepared for GPIO_BIT() macro removing.
Do it ;)

Signed-off-by: Grygorii Strashko <grygorii.strashko@linaro.org>
---
 drivers/gpio/gpio-omap.c | 4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index b39faa8..dd7934a 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -82,7 +82,6 @@ struct gpio_bank {
 };
 
 #define GPIO_INDEX(bank, gpio) (gpio % bank->width)
-#define GPIO_BIT(bank, gpio) (BIT(GPIO_INDEX(bank, gpio)))
 #define GPIO_MOD_CTRL_BIT	BIT(0)
 
 #define BANK_USED(bank) (bank->mod_usage || bank->irq_usage)
@@ -863,7 +862,6 @@ static void omap_gpio_unmask_irq(struct irq_data *d)
 {
 	struct gpio_bank *bank = omap_irq_data_get_bank(d);
 	unsigned offset = d->hwirq;
-	unsigned int irq_mask = GPIO_BIT(bank, gpio);
 	u32 trigger = irqd_get_trigger_type(d);
 	unsigned long flags;
 
@@ -873,7 +871,7 @@ static void omap_gpio_unmask_irq(struct irq_data *d)
 
 	/* For level-triggered GPIOs, the clearing must be done after
 	 * the HW source is cleared, thus after the handler has run */
-	if (bank->level_mask & irq_mask) {
+	if (bank->level_mask & BIT(offset)) {
 		omap_set_gpio_irqenable(bank, offset, 0);
 		omap_clear_gpio_irqstatus(bank, offset);
 	}
-- 
1.9.1