From mboxrd@z Thu Jan 1 00:00:00 1970 From: Geert Uytterhoeven Subject: [PATCH 23/27] backlight: Allow compile test of GPIO consumers if !GPIOLIB Date: Tue, 5 May 2015 18:32:39 +0200 Message-ID: <1430843563-18615-23-git-send-email-geert@linux-m68k.org> References: <1430836404-15513-1-git-send-email-geert@linux-m68k.org> <1430843563-18615-1-git-send-email-geert@linux-m68k.org> Return-path: Received: from andre.telenet-ops.be ([195.130.132.53]:59385 "EHLO andre.telenet-ops.be" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1761373AbbEEQc4 (ORCPT ); Tue, 5 May 2015 12:32:56 -0400 In-Reply-To: <1430843563-18615-1-git-send-email-geert@linux-m68k.org> Sender: linux-gpio-owner@vger.kernel.org List-Id: linux-gpio@vger.kernel.org To: Linus Walleij , Alexandre Courbot , Arnd Bergmann Cc: linux-gpio@vger.kernel.org, linux-kernel@vger.kernel.org, Geert Uytterhoeven , Jingoo Han , Lee Jones , Jean-Christophe Plagniol-Villard , Tomi Valkeinen , linux-fbdev@vger.kernel.org The GPIO subsystem provides dummy GPIO consumer functions if GPIOLIB is not enabled. Hence drivers that depend on GPIOLIB, but use GPIO consumer functionality only, can still be compiled if GPIOLIB is not enabled. Relax the dependency on GPIOLIB if COMPILE_TEST is enabled, where appropriate. Signed-off-by: Geert Uytterhoeven Cc: Jingoo Han Cc: Lee Jones Cc: Jean-Christophe Plagniol-Villard Cc: Tomi Valkeinen Cc: linux-fbdev@vger.kernel.org --- drivers/video/backlight/Kconfig | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-) diff --git a/drivers/video/backlight/Kconfig b/drivers/video/backlight/Kconfig index 2d9923a60076e380..0505b796d743250e 100644 --- a/drivers/video/backlight/Kconfig +++ b/drivers/video/backlight/Kconfig @@ -36,14 +36,16 @@ config LCD_CORGI config LCD_L4F00242T03 tristate "Epson L4F00242T03 LCD" - depends on SPI_MASTER && GPIOLIB + depends on SPI_MASTER + depends on GPIOLIB || COMPILE_TEST help SPI driver for Epson L4F00242T03. This provides basic support for init and powering the LCD up/down through a sysfs interface. config LCD_LMS283GF05 tristate "Samsung LMS283GF05 LCD" - depends on SPI_MASTER && GPIOLIB + depends on SPI_MASTER + depends on GPIOLIB || COMPILE_TEST help SPI driver for Samsung LMS283GF05. This provides basic support for powering the LCD up/down through a sysfs interface. @@ -434,7 +436,7 @@ config BACKLIGHT_AS3711 config BACKLIGHT_GPIO tristate "Generic GPIO based Backlight Driver" - depends on GPIOLIB + depends on GPIOLIB || COMPILE_TEST help If you have a LCD backlight adjustable by GPIO, say Y to enable this driver. -- 1.9.1