From: <patrice.chotard@st.com>
To: Russell King <linux@armlinux.org.uk>,
Ulf Hansson <ulf.hansson@linaro.org>,
Michael Turquette <mturquette@baylibre.com>,
Stephen Boyd <sboyd@codeaurora.org>,
Linus Walleij <linus.walleij@linaro.org>,
Rob Herring <robh+dt@kernel.org>,
Mark Rutland <mark.rutland@arm.com>,
Alexandre Torgue <alexandre.torgue@st.com>
Cc: linux-mmc@vger.kernel.org, linux-kernel@vger.kernel.org,
linux-clk@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
linux-gpio@vger.kernel.org, devicetree@vger.kernel.org,
Patrice Chotard <patrice.chotard@st.com>
Subject: [PATCH v3 00/14] Add MMCI support for STM32F SoCs family
Date: Thu, 18 Jan 2018 15:34:16 +0100 [thread overview]
Message-ID: <1516286070-24927-1-git-send-email-patrice.chotard@st.com> (raw)
From: Patrice Chotard <patrice.chotard@st.com>
This series reworks patches submitted one year ago by Andrea Merello [1]
but without succeed to merged it.
STM32F4 and STM32F7 SoCs families embeds a variant of the ARM PrimeCell
PL18x SD host controller, for which the mmci driver exists.
This series adds support for these SoCs to the mmci driver.
As other variants, this one need some specific quirks, that this
series address.
This series has been tested on following boards :
_ stm32f429-eval
_ stm32f469-disco
_ stm32f746-eval
_ stm32f769-disco
DT update for stm32f7 pinctrl, stm32f746-eval and stm32f769-disco boards
will be sent later to avoid conflict with pending stm32f7 series [1] which
is not yet merged on kernel mainline.
[1] https://www.spinics.net/lists/linux-mmc/msg41616.html
[2] https://patchwork.kernel.org/patch/10104447/
v3: _ patch 3: use variant->opendrain instead of host->variant->opendrain
_ patch 4: exit from probe() if no pinctrl dt node are found
_ previous patch 15: removed as already applied in pinctrl tree
v2: _ add Revievied-by, Acked-by in some patches
_ replace bool by u32 for start_err and opendrain fields of struct variant_data
_ split previous patch 3 in two parts, first patch clean the open drain bit code
and second part add pinctrl pins management when no open drain bit is available.
_ replace "pl180" by "PL180" in patch "mmc: mmci: Add STM32 variant"
Andrea Merello (2):
ARM: dts: stm32: Add pin map for SDIO controller on stm32f4
ARM: dts: stm32: Enable SDIO controller on stm32f469 disco board
Patrice Chotard (12):
mmc: mmci: Don't pretend all variants to have MMCIMASK1 register
mmc: mmci: Don't pretend all variants to have MCI_STARBITERR flag
mmc: mmci: Don't pretend all variants to have OPENDRAIN bit
mmc: mmci: Add support for setting pad type via pinctrl
mmc: mmci: Add STM32 variant
ARM: dts: stm32: Add SDIO controller for stm32f746
ARM: dts: stm32: Add SDIO controller for stm32f429
ARM: dts: stm32: Enable SDIO controller on stm32429i-eval board
ARM: stm32: Add AMBA support for STM32F4 and STM32F7 SoCs
ARM: configs: stm32: Enable MMC_ARMMMCI support
ARM: configs: stm32: Enable EXT3_FS support
clk: stm32: Add clk entry for SDMMC2 on stm32F769
arch/arm/boot/dts/stm32429i-eval.dts | 19 +++++
arch/arm/boot/dts/stm32f4-pinctrl.dtsi | 31 +++++++++
arch/arm/boot/dts/stm32f429.dtsi | 11 +++
arch/arm/boot/dts/stm32f469-disco.dts | 19 +++++
arch/arm/boot/dts/stm32f746.dtsi | 22 ++++++
arch/arm/configs/stm32_defconfig | 3 +
arch/arm/mach-stm32/Kconfig | 3 +
drivers/clk/clk-stm32f4.c | 3 +-
drivers/mmc/host/mmci.c | 124 ++++++++++++++++++++++++++++-----
drivers/mmc/host/mmci.h | 6 ++
10 files changed, 224 insertions(+), 17 deletions(-)
--
1.9.1
next reply other threads:[~2018-01-18 14:34 UTC|newest]
Thread overview: 18+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-01-18 14:34 patrice.chotard [this message]
2018-01-18 14:34 ` [PATCH v3 01/14] mmc: mmci: Don't pretend all variants to have MMCIMASK1 register patrice.chotard
2018-01-18 14:34 ` [PATCH v3 02/14] mmc: mmci: Don't pretend all variants to have MCI_STARBITERR flag patrice.chotard
2018-01-18 14:34 ` [PATCH v3 03/14] mmc: mmci: Don't pretend all variants to have OPENDRAIN bit patrice.chotard
2018-01-18 14:34 ` [PATCH v3 04/14] mmc: mmci: Add support for setting pad type via pinctrl patrice.chotard
2018-01-18 14:34 ` [PATCH v3 05/14] mmc: mmci: Add STM32 variant patrice.chotard
2018-01-18 14:34 ` [PATCH v3 06/14] ARM: dts: stm32: Add SDIO controller for stm32f746 patrice.chotard
2018-01-18 14:34 ` [PATCH v3 07/14] ARM: dts: stm32: Add SDIO controller for stm32f429 patrice.chotard
2018-01-18 14:34 ` [PATCH v3 08/14] ARM: dts: stm32: Add pin map for SDIO controller on stm32f4 patrice.chotard
2018-01-18 14:34 ` [PATCH v3 09/14] ARM: dts: stm32: Enable SDIO controller on stm32f469 disco board patrice.chotard
2018-01-18 14:34 ` [PATCH v3 10/14] ARM: dts: stm32: Enable SDIO controller on stm32429i-eval board patrice.chotard
2018-01-18 14:34 ` [PATCH v3 11/14] ARM: stm32: Add AMBA support for STM32F4 and STM32F7 SoCs patrice.chotard
2018-01-18 14:34 ` [PATCH v3 12/14] ARM: configs: stm32: Enable MMC_ARMMMCI support patrice.chotard
2018-01-18 14:34 ` [PATCH v3 13/14] ARM: configs: stm32: Enable EXT3_FS support patrice.chotard
2018-01-18 14:34 ` [PATCH v3 14/14] clk: stm32: Add clk entry for SDMMC2 on stm32F769 patrice.chotard
2018-01-18 17:01 ` [PATCH v3 00/14] Add MMCI support for STM32F SoCs family Alexandre Torgue
[not found] ` <1516286070-24927-1-git-send-email-patrice.chotard-qxv4g6HH51o@public.gmane.org>
2018-01-18 17:16 ` Ulf Hansson
2018-02-27 13:25 ` Alexandre Torgue
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1516286070-24927-1-git-send-email-patrice.chotard@st.com \
--to=patrice.chotard@st.com \
--cc=alexandre.torgue@st.com \
--cc=devicetree@vger.kernel.org \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mmc@vger.kernel.org \
--cc=linux@armlinux.org.uk \
--cc=mark.rutland@arm.com \
--cc=mturquette@baylibre.com \
--cc=robh+dt@kernel.org \
--cc=sboyd@codeaurora.org \
--cc=ulf.hansson@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).