Re: [PATCH 2/2] iio: misc: add support for GPIO power switches

[Sebastian Reichel <sre@kernel.org>]

[-- Attachment #1: Type: text/plain, Size: 1139 bytes --]

Hi Linux,

On Wed, Dec 28, 2016 at 01:50:17PM +0100, Linus Walleij wrote:
> On Sun, Dec 11, 2016 at 11:21 PM, Bartosz Golaszewski
> <bgolaszewski@baylibre.com> wrote:
> 
> > Some power-measuring ADCs work together with power load switches which
> > allow to power-cycle measured devices.
> >
> > An example use case would be measuring the power consumption of a
> > development board during boot using a power monitor such as TI INA226
> > and power-cycling the board remotely using a TPS229* power switch.
> >
> > Add an iio driver for simple GPIO power switches and expose a sysfs
> > attribute allowing to toggle their state.
> >
> > Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
> 
> I don't get this, isn't this doing the same as
> drivers/power/reset/gpio-poweroff.c
> ?
> 
> With the only difference that the latter uses the standard syscall
> from pm_power_off to reboot the system instead of some random
> sysfs file.

As far as I understand it, the TPS229 is used by Barzosz to poweroff
a remote system. The gpio-poweroff driver is used to poweroff the
local system.

-- Sebastian

[-- Attachment #2: signature.asc --]
[-- Type: application/pgp-signature, Size: 833 bytes --]