[PATCH 1/5] dt-bindings: pinctrl: Add gpio bindings for Actions S900 SoC

[Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>]

Add gpio bindings for Actions Semi S900 SoC.

Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
---
 .../devicetree/bindings/pinctrl/actions,s900-pinctrl.txt    | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/Documentation/devicetree/bindings/pinctrl/actions,s900-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/actions,s900-pinctrl.txt
index fb87c7d74f2e..300a50783aab 100644
--- a/Documentation/devicetree/bindings/pinctrl/actions,s900-pinctrl.txt
+++ b/Documentation/devicetree/bindings/pinctrl/actions,s900-pinctrl.txt
@@ -8,6 +8,15 @@ Required Properties:
 - reg:          Should contain the register base address and size of
                 the pin controller.
 - clocks:       phandle of the clock feeding the pin controller
+- gpio-controller: Marks the device node as a GPIO controller.
+- #gpio-cells:     Should be two. The first cell is the gpio pin number
+                   and the second cell is used for optional parameters.
+- interrupt-controller: Marks the device node as an interrupt controller.
+- #interrupt-cells:      Specifies the number of cells needed to encode an
+                        interrupt.  Shall be set to 2.  The first cell
+                        defines the interrupt number, the second encodes
+                        the trigger flags described in
+                        bindings/interrupt-controller/interrupts.txt
 
 Please refer to pinctrl-bindings.txt in this directory for details of the
 common pinctrl bindings used by client devices, including the meaning of the
@@ -164,6 +173,10 @@ Example:
                   compatible = "actions,s900-pinctrl";
                   reg = <0x0 0xe01b0000 0x0 0x1000>;
                   clocks = <&cmu CLK_GPIO>;
+                  gpio-controller;
+                  #gpio-cells = <2>;
+                  interrupt-controller;
+                  #interrupt-cells = <2>;
 
                   uart2-default: uart2-default {
                           pinmux {
-- 
2.14.1