[PATCH AUTOSEL 4.9 33/73] gpio: omap: fix lack of irqstatus_raw0 for OMAP4

[PATCH AUTOSEL 4.9 33/73] gpio: omap: fix lack of irqstatus_raw0 for OMAP4

[Sasha Levin]

From: Russell King <rmk+kernel@armlinux.org.uk>

[ Upstream commit 64ea3e9094a1f13b96c33244a3fb3a0f45690bd2 ]

Commit 384ebe1c2849 ("gpio/omap: Add DT support to GPIO driver") added
the register definition tables to the gpio-omap driver. Subsequently to
that commit, commit 4e962e8998cc ("gpio/omap: remove cpu_is_omapxxxx()
checks from *_runtime_resume()") added definitions for irqstatus_raw*
registers to the legacy OMAP4 definitions, but missed the DT
definitions.

This causes an unintentional change of behaviour for the 1.101 errata
workaround on OMAP4 platforms. Fix this oversight.

Fixes: 4e962e8998cc ("gpio/omap: remove cpu_is_omapxxxx() checks from *_runtime_resume()")
Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Tested-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/gpio/gpio-omap.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index 038882183bdf..bd12b433f964 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -1585,6 +1585,8 @@ static struct omap_gpio_reg_offs omap4_gpio_regs = {
 	.clr_dataout =		OMAP4_GPIO_CLEARDATAOUT,
 	.irqstatus =		OMAP4_GPIO_IRQSTATUS0,
 	.irqstatus2 =		OMAP4_GPIO_IRQSTATUS1,
+	.irqstatus_raw0 =	OMAP4_GPIO_IRQSTATUSRAW0,
+	.irqstatus_raw1 =	OMAP4_GPIO_IRQSTATUSRAW1,
 	.irqenable =		OMAP4_GPIO_IRQSTATUSSET0,
 	.irqenable2 =		OMAP4_GPIO_IRQSTATUSSET1,
 	.set_irqenable =	OMAP4_GPIO_IRQSTATUSSET0,
-- 
2.20.1

[PATCH AUTOSEL 4.9 34/73] gpio: omap: ensure irq is enabled before wakeup

[Sasha Levin]

From: Russell King <rmk+kernel@armlinux.org.uk>

[ Upstream commit c859e0d479b3b4f6132fc12637c51e01492f31f6 ]

Documentation states:

  NOTE: There must be a correlation between the wake-up enable and
  interrupt-enable registers. If a GPIO pin has a wake-up configured
  on it, it must also have the corresponding interrupt enabled (on
  one of the two interrupt lines).

Ensure that this condition is always satisfied by enabling the detection
events after enabling the interrupt, and disabling the detection before
disabling the interrupt.  This ensures interrupt/wakeup events can not
happen until both the wakeup and interrupt enables correlate.

If we do any clearing, clear between the interrupt enable/disable and
trigger setting.

Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Tested-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/gpio/gpio-omap.c | 15 ++++++++-------
 1 file changed, 8 insertions(+), 7 deletions(-)

diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index bd12b433f964..fc841ce24db7 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -786,9 +786,9 @@ static void omap_gpio_irq_shutdown(struct irq_data *d)
 
 	raw_spin_lock_irqsave(&bank->lock, flags);
 	bank->irq_usage &= ~(BIT(offset));
-	omap_set_gpio_irqenable(bank, offset, 0);
-	omap_clear_gpio_irqstatus(bank, offset);
 	omap_set_gpio_triggering(bank, offset, IRQ_TYPE_NONE);
+	omap_clear_gpio_irqstatus(bank, offset);
+	omap_set_gpio_irqenable(bank, offset, 0);
 	if (!LINE_USED(bank->mod_usage, offset))
 		omap_clear_gpio_debounce(bank, offset);
 	omap_disable_gpio_module(bank, offset);
@@ -830,8 +830,8 @@ static void omap_gpio_mask_irq(struct irq_data *d)
 	unsigned long flags;
 
 	raw_spin_lock_irqsave(&bank->lock, flags);
-	omap_set_gpio_irqenable(bank, offset, 0);
 	omap_set_gpio_triggering(bank, offset, IRQ_TYPE_NONE);
+	omap_set_gpio_irqenable(bank, offset, 0);
 	raw_spin_unlock_irqrestore(&bank->lock, flags);
 }
 
@@ -843,9 +843,6 @@ static void omap_gpio_unmask_irq(struct irq_data *d)
 	unsigned long flags;
 
 	raw_spin_lock_irqsave(&bank->lock, flags);
-	if (trigger)
-		omap_set_gpio_triggering(bank, offset, trigger);
-
 	omap_set_gpio_irqenable(bank, offset, 1);
 
 	/*
@@ -853,9 +850,13 @@ static void omap_gpio_unmask_irq(struct irq_data *d)
 	 * is cleared, thus after the handler has run. OMAP4 needs this done
 	 * after enabing the interrupt to clear the wakeup status.
 	 */
-	if (bank->level_mask & BIT(offset))
+	if (bank->regs->leveldetect0 && bank->regs->wkup_en &&
+	    trigger & (IRQ_TYPE_LEVEL_HIGH | IRQ_TYPE_LEVEL_LOW))
 		omap_clear_gpio_irqstatus(bank, offset);
 
+	if (trigger)
+		omap_set_gpio_triggering(bank, offset, trigger);
+
 	raw_spin_unlock_irqrestore(&bank->lock, flags);
 }
 
-- 
2.20.1

[PATCH AUTOSEL 4.9 67/73] gpiolib: Fix references to gpiod_[gs]et_*value_cansleep() variants

[Sasha Levin]

From: Geert Uytterhoeven <geert+renesas@glider.be>

[ Upstream commit 3285170f28a850638794cdfe712eb6d93e51e706 ]

Commit 372e722ea4dd4ca1 ("gpiolib: use descriptors internally") renamed
the functions to use a "gpiod" prefix, and commit 79a9becda8940deb
("gpiolib: export descriptor-based GPIO interface") introduced the "raw"
variants, but both changes forgot to update the comments.

Readd a similar reference to gpiod_set_value(), which was accidentally
removed by commit 1e77fc82110ac36f ("gpio: Add missing open drain/source
handling to gpiod_set_value_cansleep()").

Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Link: https://lore.kernel.org/r/20190701142738.25219-1-geert+renesas@glider.be
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/gpio/gpiolib.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/gpio/gpiolib.c b/drivers/gpio/gpiolib.c
index 9e2fe12c2858..a3251faa3ed8 100644
--- a/drivers/gpio/gpiolib.c
+++ b/drivers/gpio/gpiolib.c
@@ -2411,7 +2411,7 @@ static int _gpiod_get_raw_value(const struct gpio_desc *desc)
 int gpiod_get_raw_value(const struct gpio_desc *desc)
 {
 	VALIDATE_DESC(desc);
-	/* Should be using gpio_get_value_cansleep() */
+	/* Should be using gpiod_get_raw_value_cansleep() */
 	WARN_ON(desc->gdev->chip->can_sleep);
 	return _gpiod_get_raw_value(desc);
 }
@@ -2432,7 +2432,7 @@ int gpiod_get_value(const struct gpio_desc *desc)
 	int value;
 
 	VALIDATE_DESC(desc);
-	/* Should be using gpio_get_value_cansleep() */
+	/* Should be using gpiod_get_value_cansleep() */
 	WARN_ON(desc->gdev->chip->can_sleep);
 
 	value = _gpiod_get_raw_value(desc);
@@ -2608,7 +2608,7 @@ void gpiod_set_array_value_complex(bool raw, bool can_sleep,
 void gpiod_set_raw_value(struct gpio_desc *desc, int value)
 {
 	VALIDATE_DESC_VOID(desc);
-	/* Should be using gpiod_set_value_cansleep() */
+	/* Should be using gpiod_set_raw_value_cansleep() */
 	WARN_ON(desc->gdev->chip->can_sleep);
 	_gpiod_set_raw_value(desc, value);
 }
-- 
2.20.1