[PATCH 1/2] dt-bindings: gpio: brcm: Add bindings for xgs-iproc

[Chris Packham <chris.packham@alliedtelesis.co.nz>]

This GPIO controller is present on a number of Broadcom switch ASICs
with integrated SoCs. It is similar to the nsp-gpio and iproc-gpio
blocks but different enough to require a separate driver.

Signed-off-by: Chris Packham <chris.packham@alliedtelesis.co.nz>
---
 .../bindings/gpio/brcm,xgs-iproc.txt          | 41 +++++++++++++++++++
 1 file changed, 41 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/gpio/brcm,xgs-iproc.txt

diff --git a/Documentation/devicetree/bindings/gpio/brcm,xgs-iproc.txt b/Documentation/devicetree/bindings/gpio/brcm,xgs-iproc.txt
new file mode 100644
index 000000000000..328b844c82dc
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/brcm,xgs-iproc.txt
@@ -0,0 +1,41 @@
+Broadcom XGS iProc GPIO controller
+
+This controller is the Chip Common A GPIO present on a number of Broadcom
+switch ASICs with integrated SoCs.
+
+Required properties:
+- compatible:
+    Must be "brcm,iproc-gpio-cca"
+
+- reg:
+    The first region defines the base I/O address containing
+    the GPIO controller registers. The second region defines
+    the I/O address containing the Chip Common A interrupt
+    registers.
+
+Optional properties:
+
+- interrupts:
+    The interrupt shared by all GPIO lines for this controller.
+
+- #interrupt-cells:
+    Should be <2>.  The first cell is the GPIO number, the second should specify
+    flags.
+
+    See also Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
+
+- interrupt-controller:
+    Marks the device node as an interrupt controller
+
+Example:
+	gpioa: gpio@18000060 {
+		compatible = "brcm,iproc-gpio-cca";
+		#gpio-cells = <2>;
+		reg = <0x18000060 0x50>,
+		      <0x18000000 0x50>;
+		ngpios = <12>;
+		gpio-controller;
+		interrupt-controller;
+		#interrupt-cells = <2>;
+		interrupts = <GIC_SPI 91 IRQ_TYPE_LEVEL_HIGH>;
+	};
-- 
2.23.0