[PATCH v9 net-next 3/7] pinctrl: ocelot: add ability to be used in a non-mmio configuration

[Colin Foster <colin.foster@in-advantage.com>]

There are a few Ocelot chips that contain pinctrl logic, but can be
controlled externally. Specifically the VSC7511, 7512, 7513 and 7514. In
the externally controlled configurations these registers are not
memory-mapped.

Add support for these non-memory-mapped configurations.

Signed-off-by: Colin Foster <colin.foster@in-advantage.com>
---
 drivers/pinctrl/pinctrl-ocelot.c | 10 +++-------
 1 file changed, 3 insertions(+), 7 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-ocelot.c b/drivers/pinctrl/pinctrl-ocelot.c
index 5f4a8c5c6650..7ac12102120f 100644
--- a/drivers/pinctrl/pinctrl-ocelot.c
+++ b/drivers/pinctrl/pinctrl-ocelot.c
@@ -10,6 +10,7 @@
 #include <linux/gpio/driver.h>
 #include <linux/interrupt.h>
 #include <linux/io.h>
+#include <linux/mfd/ocelot.h>
 #include <linux/of_device.h>
 #include <linux/of_irq.h>
 #include <linux/of_platform.h>
@@ -1917,7 +1918,6 @@ static int ocelot_pinctrl_probe(struct platform_device *pdev)
 	struct ocelot_pinctrl *info;
 	struct reset_control *reset;
 	struct regmap *pincfg;
-	void __iomem *base;
 	int ret;
 	struct regmap_config regmap_config = {
 		.reg_bits = 32,
@@ -1937,16 +1937,12 @@ static int ocelot_pinctrl_probe(struct platform_device *pdev)
 				     "Failed to get reset\n");
 	reset_control_reset(reset);
 
-	base = devm_ioremap_resource(dev,
-			platform_get_resource(pdev, IORESOURCE_MEM, 0));
-	if (IS_ERR(base))
-		return PTR_ERR(base);
-
 	info->stride = 1 + (info->desc->npins - 1) / 32;
 
 	regmap_config.max_register = OCELOT_GPIO_SD_MAP * info->stride + 15 * 4;
 
-	info->map = devm_regmap_init_mmio(dev, base, &regmap_config);
+	ocelot_platform_init_regmap_from_resource(pdev, 0, &info->map, NULL,
+						  &regmap_config);
 	if (IS_ERR(info->map)) {
 		dev_err(dev, "Failed to create regmap\n");
 		return PTR_ERR(info->map);
-- 
2.25.1