From: Kent Gibson <warthog618@gmail.com>
To: Viresh Kumar <viresh.kumar@linaro.org>
Cc: "Linus Walleij" <linus.walleij@linaro.org>,
"Bartosz Golaszewski" <brgl@bgdev.pl>,
"Vincent Guittot" <vincent.guittot@linaro.org>,
linux-gpio@vger.kernel.org,
"Miguel Ojeda" <miguel.ojeda.sandonis@gmail.com>,
"Wedson Almeida Filho" <wedsonaf@google.com>,
"Alex Bennée" <alex.bennee@linaro.org>,
stratos-dev@op-lists.linaro.org,
"Gerard Ryan" <g.m0n3y.2503@gmail.com>
Subject: Re: [PATCH V4 8/8] libgpiod: Integrate building of rust bindings with make
Date: Wed, 27 Jul 2022 14:45:03 +0800 [thread overview]
Message-ID: <20220727064503.GA112390@sol> (raw)
In-Reply-To: <20220727063527.xspojxe3w2tpg7k5@vireshk-i7>
On Wed, Jul 27, 2022 at 12:05:27PM +0530, Viresh Kumar wrote:
> On 27-07-22, 14:25, Kent Gibson wrote:
> > So you can't run tests on those platforms where bindgen is problematic?
>
> Specifically for my case, that environment (rust-vmm-container) never runs
> libgpiod tests, but just vhost-device/gpio tests. So it works.
>
That may work for you, but in general it would be better if the tests
can be run even if the bindings can't be regenerated, so the two should
be independent.
Cheers,
Kent.
next prev parent reply other threads:[~2022-07-27 6:47 UTC|newest]
Thread overview: 66+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-07-08 11:34 [PATCH V4 0/8] libgpiod: Add Rust bindings Viresh Kumar
2022-07-08 11:34 ` [PATCH V4 1/8] libgpiod: Add libgpiod-sys rust crate Viresh Kumar
2022-07-27 2:57 ` Kent Gibson
2022-07-27 4:51 ` Viresh Kumar
2022-07-27 5:17 ` Kent Gibson
2022-07-27 5:45 ` Viresh Kumar
2022-08-01 12:11 ` Viresh Kumar
2022-08-01 15:56 ` Kent Gibson
2022-08-02 8:50 ` Viresh Kumar
2022-08-02 9:36 ` Kent Gibson
2022-07-08 11:34 ` [PATCH V4 2/8] libgpiod: Add pre generated rust bindings Viresh Kumar
2022-07-27 2:57 ` Kent Gibson
2022-07-27 5:15 ` Viresh Kumar
2022-07-27 5:31 ` Kent Gibson
2022-07-27 6:00 ` Viresh Kumar
2022-07-27 6:06 ` Kent Gibson
2022-07-08 11:34 ` [PATCH V4 3/8] libgpiod-sys: Add support to generate gpiosim bindings Viresh Kumar
2022-07-27 2:57 ` Kent Gibson
2022-07-27 5:30 ` Viresh Kumar
2022-07-08 11:34 ` [PATCH V4 4/8] libgpiod: Add rust wrapper crate Viresh Kumar
2022-07-27 2:57 ` Kent Gibson
2022-07-27 9:07 ` Viresh Kumar
2022-07-27 10:08 ` Kent Gibson
2022-07-27 11:06 ` Miguel Ojeda
2022-07-27 12:40 ` Kent Gibson
2022-07-27 13:02 ` Miguel Ojeda
2022-07-28 3:11 ` Kent Gibson
2022-07-29 4:40 ` Viresh Kumar
2022-07-28 3:10 ` Kent Gibson
2022-08-01 12:05 ` Viresh Kumar
2022-08-01 13:20 ` Kent Gibson
2022-08-01 13:28 ` Miguel Ojeda
2022-07-28 8:52 ` Viresh Kumar
2022-07-28 9:59 ` Kent Gibson
2022-07-08 11:34 ` [PATCH V4 5/8] libgpiod: Add rust examples Viresh Kumar
2022-07-27 2:58 ` Kent Gibson
2022-07-27 9:23 ` Viresh Kumar
2022-07-27 9:59 ` Kent Gibson
2022-07-27 10:06 ` Viresh Kumar
2022-07-27 10:32 ` Kent Gibson
2022-07-27 10:33 ` Viresh Kumar
2022-07-08 11:34 ` [PATCH V4 6/8] libgpiod: Derive debug traits for few definitions Viresh Kumar
2022-07-27 2:58 ` Kent Gibson
2022-07-27 6:20 ` Viresh Kumar
2022-07-08 11:35 ` [PATCH V4 7/8] libgpiod: Add rust tests Viresh Kumar
2022-07-27 2:58 ` Kent Gibson
2022-07-27 9:59 ` Viresh Kumar
2022-07-27 10:27 ` Kent Gibson
2022-08-01 11:54 ` Viresh Kumar
2022-08-01 12:38 ` Kent Gibson
2022-08-02 5:44 ` Viresh Kumar
2022-08-02 5:47 ` Kent Gibson
2022-07-08 11:35 ` [PATCH V4 8/8] libgpiod: Integrate building of rust bindings with make Viresh Kumar
2022-07-27 2:59 ` Kent Gibson
2022-07-27 6:18 ` Viresh Kumar
2022-07-27 6:25 ` Kent Gibson
2022-07-27 6:35 ` Viresh Kumar
2022-07-27 6:45 ` Kent Gibson [this message]
2022-07-27 6:51 ` Viresh Kumar
2022-07-15 19:07 ` [PATCH V4 0/8] libgpiod: Add Rust bindings Bartosz Golaszewski
2022-07-15 19:17 ` Miguel Ojeda
2022-07-15 19:27 ` Miguel Ojeda
2022-07-16 9:43 ` Miguel Ojeda
2022-07-16 10:43 ` Bartosz Golaszewski
2022-07-16 12:23 ` Kent Gibson
2022-07-16 13:46 ` Miguel Ojeda
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20220727064503.GA112390@sol \
--to=warthog618@gmail.com \
--cc=alex.bennee@linaro.org \
--cc=brgl@bgdev.pl \
--cc=g.m0n3y.2503@gmail.com \
--cc=linus.walleij@linaro.org \
--cc=linux-gpio@vger.kernel.org \
--cc=miguel.ojeda.sandonis@gmail.com \
--cc=stratos-dev@op-lists.linaro.org \
--cc=vincent.guittot@linaro.org \
--cc=viresh.kumar@linaro.org \
--cc=wedsonaf@google.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).