[PATCH v1 13/16] gpio: wcove: Utilize helpers from string_choices.h

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

There are a few helpers available to convert a boolean variable
to the dedicated string literals depending on the application.
Use them in the driver.

While at, utilize specifier field for padding the strings where
it's required.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 drivers/gpio/gpio-wcove.c | 15 ++++++++-------
 1 file changed, 8 insertions(+), 7 deletions(-)

diff --git a/drivers/gpio/gpio-wcove.c b/drivers/gpio/gpio-wcove.c
index c18b6b47384f..8d30fd04dede 100644
--- a/drivers/gpio/gpio-wcove.c
+++ b/drivers/gpio/gpio-wcove.c
@@ -15,6 +15,7 @@
 #include <linux/platform_device.h>
 #include <linux/regmap.h>
 #include <linux/seq_file.h>
+#include <linux/string_choices.h>
 
 /*
  * Whiskey Cove PMIC has 13 physical GPIO pins divided into 3 banks:
@@ -391,14 +392,14 @@ static void wcove_gpio_dbg_show(struct seq_file *s, struct gpio_chip *chip)
 			break;
 		}
 
-		seq_printf(s, " gpio-%-2d %s %s %s %s ctlo=%2x,%s %s\n",
-			   gpio, ctlo & CTLO_DIR_OUT ? "out" : "in ",
-			   ctli & 0x1 ? "hi" : "lo",
-			   ctli & CTLI_INTCNT_NE ? "fall" : "    ",
-			   ctli & CTLI_INTCNT_PE ? "rise" : "    ",
+		seq_printf(s, " gpio-%-2d %-3.3s %-2.2s %-4.4s %-4.4s ctlo=%2x,%-6.6s %s\n",
+			   gpio, str_out_in(ctlo & CTLO_DIR_OUT),
+			   str_hi_lo(ctli & BIT(0)),
+			   ctli & CTLI_INTCNT_NE ? "fall" : "",
+			   ctli & CTLI_INTCNT_PE ? "rise" : "",
 			   ctlo,
-			   irq_mask & mask ? "mask  " : "unmask",
-			   irq_status & mask ? "pending" : "       ");
+			   irq_mask & mask ? "mask" : "unmask",
+			   irq_status & mask ? "pending" : "");
 	}
 }
 
-- 
2.39.1