[PATCH 2/5] mtd: rawnand: ingenic: use gpiod_set_active_high()

[Bartosz Golaszewski <brgl@bgdev.pl>]

From: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

Use the new, less cumbersome interface for setting the GPIO as
active-high that doesn't require first checking the current state.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
---
 drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c b/drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c
index 6748226b8bd1..c055133c45fe 100644
--- a/drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c
+++ b/drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c
@@ -388,9 +388,8 @@ static int ingenic_nand_init_chip(struct platform_device *pdev,
 	 * here for older DTs so we can re-use the generic nand_gpio_waitrdy()
 	 * helper, and be consistent with what other drivers do.
 	 */
-	if (of_machine_is_compatible("qi,lb60") &&
-	    gpiod_is_active_low(nand->busy_gpio))
-		gpiod_toggle_active_low(nand->busy_gpio);
+	if (of_machine_is_compatible("qi,lb60"))
+		gpiod_set_active_high(nand->busy_gpio);
 
 	nand->wp_gpio = devm_gpiod_get_optional(dev, "wp", GPIOD_OUT_LOW);
 
-- 
2.39.2