From: Bhargav Raviprakash <bhargav.r@ltts.com>
To: linux-kernel@vger.kernel.org
Cc: m.nirmaladevi@ltts.com, lee@kernel.org, robh+dt@kernel.org,
krzysztof.kozlowski+dt@linaro.org, conor+dt@kernel.org,
jpanis@baylibre.com, devicetree@vger.kernel.org, arnd@arndb.de,
gregkh@linuxfoundation.org, lgirdwood@gmail.com,
broonie@kernel.org, linus.walleij@linaro.org,
linux-gpio@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
nm@ti.com, vigneshr@ti.com, kristo@kernel.org,
eblanc@baylibre.com, Bhargav Raviprakash <bhargav.r@ltts.com>
Subject: [PATCH v5 00/11] Add support for TI TPS65224 PMIC
Date: Thu, 28 Mar 2024 18:10:05 +0530 [thread overview]
Message-ID: <20240328124016.161959-1-bhargav.r@ltts.com> (raw)
This series modifies the existing TPS6594 drivers to add support for the
TPS65224 PMIC device that is a derivative of TPS6594. TPS65224 has a
similar register map to TPS6594 with a few differences. SPI, I2C, ESM,
PFSM, Regulators and GPIO features overlap between the two devices.
TPS65224 is a Power Management IC (PMIC) which provides regulators and
other features like GPIOs, Watchdog, Error Signal Monitor (ESM) and
Pre-configurable Finite State Machine (PFSM). The SoC and the PMIC can
communicate through the I2C or SPI interfaces. The PMIC TPS65224
additionally has a 12-bit ADC.
Data Sheet for TPS65224: https://www.ti.com/product/TPS65224-Q1
Driver re-use is applied following the advice of the following series:
https://lore.kernel.org/lkml/2f467b0a-1d11-4ec7-8ca6-6c4ba66e5887@baylibre.com/
The features implemented in this series are:
- TPS65224 Register definitions
- Core (MFD I2C and SPI entry points)
- PFSM
- Regulators
- Pinctrl
TPS65224 Register definitions:
This patch adds macros for register field definitions of TPS65224
to the existing TPS6594 driver.
Core description:
I2C and SPI interface protocols are implemented, with and without
the bit-integrity error detection feature (CRC mode).
PFSM description:
Strictly speaking, PFSM is not hardware. It is a piece of code.
PMIC integrates a state machine which manages operational modes.
Depending on the current operational mode, some voltage domains
remain energized while others can be off.
PFSM driver can be used to trigger transitions between configured
states.
Regulators description:
4 BUCKs and 3 LDOs.
BUCK12 can be used in dual-phase mode.
Pinctrl description:
TPS65224 family has 6 GPIOs. Those GPIOs can also serve different
functions such as I2C or SPI interface or watchdog disable functions.
The driver provides both pinmuxing for the functions and GPIO capability.
This series was tested on linux-next tag: next-20240118
Test logs can be found here:
https://gist.github.com/LeonardMH/58ec135921fb1062ffd4a8b384831eb0
Changelog v4 -> v5:
- Regulator events changed to REGULATOR_EVENT_REGULATION_OUT for _UVOV
- Fixed pinctrl probe issues with TPS6593 PMIC
- Refactoring pinctrl driver: reduced no. of switch case statements and
using template structs for initializing tps6594_pinctrl.
Bhargav Raviprakash (8):
mfd: tps6594: use volatile_table instead of volatile_reg
mfd: tps6594: add regmap config in match data
dt-bindings: mfd: ti,tps6594: Add TI TPS65224 PMIC
mfd: tps6594-i2c: Add TI TPS65224 PMIC I2C
mfd: tps6594-spi: Add TI TPS65224 PMIC SPI
mfd: tps6594-core: Add TI TPS65224 PMIC core
misc: tps6594-pfsm: Add TI TPS65224 PMIC PFSM
arch: arm64: dts: ti: k3-am62p5-sk: Add TPS65224 PMIC support in AM62P
dts
Nirmala Devi Mal Nadar (3):
mfd: tps6594: Add register definitions for TI TPS65224 PMIC
regulator: tps6594-regulator: Add TI TPS65224 PMIC regulators
pinctrl: pinctrl-tps6594: Add TPS65224 PMIC pinctrl and GPIO
.../devicetree/bindings/mfd/ti,tps6594.yaml | 1 +
arch/arm64/boot/dts/ti/k3-am62p5-sk.dts | 95 +++++
drivers/mfd/tps6594-core.c | 253 ++++++++++--
drivers/mfd/tps6594-i2c.c | 41 +-
drivers/mfd/tps6594-spi.c | 43 ++-
drivers/misc/tps6594-pfsm.c | 48 ++-
drivers/pinctrl/pinctrl-tps6594.c | 275 ++++++++++---
drivers/regulator/Kconfig | 4 +-
drivers/regulator/tps6594-regulator.c | 238 ++++++++++--
include/linux/mfd/tps6594.h | 362 +++++++++++++++++-
10 files changed, 1215 insertions(+), 145 deletions(-)
base-commit: 2863b714f3ad0a9686f2de1b779228ad8c7a8052
--
2.25.1
next reply other threads:[~2024-03-28 12:40 UTC|newest]
Thread overview: 14+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-03-28 12:40 Bhargav Raviprakash [this message]
2024-03-28 12:40 ` [PATCH v5 01/11] mfd: tps6594: Add register definitions for TI TPS65224 PMIC Bhargav Raviprakash
2024-03-28 12:40 ` [PATCH v5 02/11] mfd: tps6594: use volatile_table instead of volatile_reg Bhargav Raviprakash
2024-03-28 12:40 ` [PATCH v5 03/11] mfd: tps6594: add regmap config in match data Bhargav Raviprakash
2024-03-28 12:40 ` [PATCH v5 04/11] dt-bindings: mfd: ti,tps6594: Add TI TPS65224 PMIC Bhargav Raviprakash
2024-03-28 12:40 ` [PATCH v5 05/11] mfd: tps6594-i2c: Add TI TPS65224 PMIC I2C Bhargav Raviprakash
2024-03-28 12:40 ` [PATCH v5 06/11] mfd: tps6594-spi: Add TI TPS65224 PMIC SPI Bhargav Raviprakash
2024-03-28 12:40 ` [PATCH v5 07/11] mfd: tps6594-core: Add TI TPS65224 PMIC core Bhargav Raviprakash
2024-03-28 12:40 ` [PATCH v5 08/11] misc: tps6594-pfsm: Add TI TPS65224 PMIC PFSM Bhargav Raviprakash
2024-03-28 12:40 ` [PATCH v5 09/11] regulator: tps6594-regulator: Add TI TPS65224 PMIC regulators Bhargav Raviprakash
2024-03-28 19:55 ` Mark Brown
2024-04-02 10:06 ` Dan Carpenter
2024-03-28 12:40 ` [PATCH v5 10/11] pinctrl: pinctrl-tps6594: Add TPS65224 PMIC pinctrl and GPIO Bhargav Raviprakash
2024-03-28 12:40 ` [PATCH v5 11/11] arch: arm64: dts: ti: k3-am62p5-sk: Add TPS65224 PMIC support in AM62P dts Bhargav Raviprakash
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20240328124016.161959-1-bhargav.r@ltts.com \
--to=bhargav.r@ltts.com \
--cc=arnd@arndb.de \
--cc=broonie@kernel.org \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=eblanc@baylibre.com \
--cc=gregkh@linuxfoundation.org \
--cc=jpanis@baylibre.com \
--cc=kristo@kernel.org \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=lee@kernel.org \
--cc=lgirdwood@gmail.com \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=m.nirmaladevi@ltts.com \
--cc=nm@ti.com \
--cc=robh+dt@kernel.org \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox