[PATCH] pinctrl: meson: a4: Add input enable pin configuration

[Xianwei Zhao via B4 Relay <devnull+xianwei.zhao.amlogic.com@kernel.org>]

From: Xianwei Zhao <xianwei.zhao@amlogic.com>

Add support for PIN_CONFIG_INPUT_ENABLE in the Amlogic A4 pinctrl
driver.

Use the existing output enable control to configure the input enable
state, since the hardware uses the same control with inverse semantics.

Also update PIN_CONFIG_OUTPUT_ENABLE handling to return the actual
output enable state instead of treating any non-zero value as enabled.

Signed-off-by: Xianwei Zhao <xianwei.zhao@amlogic.com>
---
 drivers/pinctrl/meson/pinctrl-amlogic-a4.c | 14 ++++++++++++--
 1 file changed, 12 insertions(+), 2 deletions(-)

diff --git a/drivers/pinctrl/meson/pinctrl-amlogic-a4.c b/drivers/pinctrl/meson/pinctrl-amlogic-a4.c
index 420f7915c010..39eb8cc7fc0d 100644
--- a/drivers/pinctrl/meson/pinctrl-amlogic-a4.c
+++ b/drivers/pinctrl/meson/pinctrl-amlogic-a4.c
@@ -469,9 +469,15 @@ static int aml_pinconf_get(struct pinctrl_dev *pcdev, unsigned int pin,
 		break;
 	case PIN_CONFIG_OUTPUT_ENABLE:
 		ret = aml_pinconf_get_output(info, pin);
-		if (ret <= 0)
+		if (ret < 0)
+			return -EINVAL;
+		arg = ret;
+		break;
+	case PIN_CONFIG_INPUT_ENABLE:
+		ret = aml_pinconf_get_output(info, pin);
+		if (ret < 0)
 			return -EINVAL;
-		arg = 1;
+		arg = !ret;
 		break;
 	case PIN_CONFIG_LEVEL:
 		ret = aml_pinconf_get_output(info, pin);
@@ -619,6 +625,7 @@ static int aml_pinconf_set(struct pinctrl_dev *pcdev, unsigned int pin,
 		switch (param) {
 		case PIN_CONFIG_DRIVE_STRENGTH_UA:
 		case PIN_CONFIG_OUTPUT_ENABLE:
+		case PIN_CONFIG_INPUT_ENABLE:
 		case PIN_CONFIG_LEVEL:
 			arg = pinconf_to_config_argument(configs[i]);
 			break;
@@ -643,6 +650,9 @@ static int aml_pinconf_set(struct pinctrl_dev *pcdev, unsigned int pin,
 		case PIN_CONFIG_OUTPUT_ENABLE:
 			ret = aml_pinconf_set_output(info, pin, arg);
 			break;
+		case PIN_CONFIG_INPUT_ENABLE:
+			ret = aml_pinconf_set_output(info, pin, !arg);
+			break;
 		case PIN_CONFIG_LEVEL:
 			ret = aml_pinconf_set_output_drive(info, pin, arg);
 			break;

---
base-commit: 761af93c9f1a100b8d9f71aa744b8f9abbbbbfb2
change-id: 20260812-input-enable-51166b444697

Best regards,
-- 
Xianwei Zhao <xianwei.zhao@amlogic.com>